Pete, We use 5 degrees (not .5) in place of the default 180 degrees for corner roll angle. The offsets match our original geometry perfectly, without the corner roll. I was told once that on 90 degree corners, anything less than 90 would work for a corner roll angle, but we just settled in on 5 and its worked fine. Jim Syrstad St. Helens High School
Pete Ruehle wrote: > I believe the little quirks of the Wall Offset command have been discussed > in the past but I don't remember anything regarding the "corner roll angle". > > Occasionally, the corner roll angle is set at .5 degrees (which results in > an error) even though I've saved defaults with the setting at 180. > > Anyone else experiencing this with pmill 11x? > > _______________________________________________________ > Peter Ruehle > Semiconductor Packaging Materials > [EMAIL PROTECTED] > http://www.sempck.com > (914) 273-5500 > > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
