Colin, Blend only works on non-parallel entities. If it's a slot with a full radius at the ends, you can't use Group Blend, as those aren't blends. If it's a slot with 4 corners, then you can use Group Blend as David suggested.
Dave -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Colin Williams Sent: Thursday, June 15, 2000 2:03 PM To: [EMAIL PROTECTED]; Mfg-Smartcam (E-mail) Subject: Re: [mfg-smartcam] Reblending a blend radii What do you do if you want to change a slot? Colin -----Original Message----- From: David Shultz <[EMAIL PROTECTED]> To: Mfg-Smartcam (E-mail) <[EMAIL PROTECTED]> Date: Thursday, June 15, 2000 12:36 PM Subject: RE: [mfg-smartcam] Reblending a blend radii >Yes just as easy as it is to blend a grouped profile you can change it to a >different radius. Re-group the profile and put the existing radius size in >the "Grp Change Radius" box and the new radius size in the "Inside Radius" >box. Group Blend and they all change from the change radius to the inside >radius size. COOL > ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
