You may want to check smf questions 138-142 and 144 they pertain to cycle time.
Thanks, J.G. -----Original Message----- From: Michael [mailto:[EMAIL PROTECTED]] Sent: Wed, September 27, 2000 8:34 AM To: David Wolfgang; 'smartcam user group' Subject: Re: [mfg-smartcam] cycle time In Freeform my Show Path outputs an accurate cycle time, when I code a program if doubles the cycle time. Show Cut also doubles the time, any ideas on how to get these two features in sync? Michael David Wolfgang wrote: > I have been using SmartCam to program and in many cases to > quote very tight running jobs. It has come to my attention > today that the cycle time is very close when not using a > tap cycle. Depending on the number of taped holes the > cycle time is longer on the machining center. Than it is > on SmartCam. Is there a way I can put a statement in my > TMP files to adjust the time > #IF(#TLTYPE=4)??????? ThanksDave Wolfgang -- Visit us at http://www.microsystemsgeorgia.com/toc.htm Smartcam Support Repository and Rhino Modeling for CNC Milling ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
