RE: [mfg-smartcam] No G80

[Dave Coupar]

Jon,   Look in your @RAP section for < #FXD>, which SHOULD output a G80. If there's not one there, you might want to add one and see if that cures your ill.   Dave -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Jon Baker Sent: Thursday, December 07, 2000 5:45 PM To: [EMAIL PROTECTED] Subject: [mfg-smartcam] No G80 Hey, who added this twist to me.     I am programming away, and need to add a point after a bore so the tool will move out of the way before tool changing.  So I process out my code, and it does the bore, then DOESN'T call a G80 up before calling out the point location.  This will cause my machine to bore again at the new location.  Strangely, this is the first time I have run into this, as generaly after using a hole cycle, you cancel out and change tools immediately. Any suggestions as to where in my tmp file I need to do something? Thanks in advance Jon