Dennis, If your're trying to run Smartcam from the old install on the slave drive, you'll have problems. It's looking in the wrong place for system files. The best thing to do is re-install SC, then copy over any customized files you may have on the slave drive.
Dave [EMAIL PROTECTED]@loki.sdrc.com on 06/07/2002 12:04:40 PM Sent by: [EMAIL PROTECTED] To: [EMAIL PROTECTED] cc: Subject: [mfg-smartcam] re: Hard ware lock Anyone My windows program went down with a virus so I left all the files and program's on the original hard drive and used it as a slave then installed a new hard drive but when I try to access smartcam it say's it's not lic so then I installed the hardware lock sent from SDR to the parallel port but the program still say's it not lic. How do I get the program to see the hardware lock on the parallel port? BRG's Dennis Fuente. JD Enterprises.LLC ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
