On an HP laser printer, you can go to "Properties" then "Graphic" and set the Resolution to a lower number. Usually 300 dots per inch will give acceptable graphics on the printout. The lower the setting, the thicker and darker the lines, but also more "blotchy" the graphics are.
-----Original Message----- From: Edgar Tejeda [mailto:[EMAIL PROTECTED]] Sent: Thursday, July 25, 2002 8:38 AM To: '[EMAIL PROTECTED]' Subject: [mfg-smartcam] Pen thickness... Hi to all! Im not to much of a contributor to this user group, but I am a daily reader and have taken with me a whole lot of helpfull information. Basically, Just want to thank you all for all your extensive knowledge in Smart Cam! P.S. : Please keep this service going! :o) Oh yeah, does any one know how to increase the pen thickness when printing out a drawing in Smart Cam? Thanks again, Edgar Tejeda Programmer Innovative Surfacing, Inc. California, USA ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
