Re: [mfg-smartcam] rapid to clearance plane

11 Oct 2002 16:43:15 -0000

Make sure to turn off prof top as well
 
Steve Rebensdorf
 
----- Original Message -----
From: Pete Ruehle
Sent: Friday, October 11, 2002 7:35 AM
To: '[EMAIL PROTECTED]'; [EMAIL PROTECTED]
Subject: RE: [mfg-smartcam] rapid to clearance plane
 
Fred,

Yes, I group the elements, go to Property Change, Toolpath, and set
Clearance to No.  I guess it's the cg forcing it, yes?

Regards,
Pete

-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]
Sent: Friday, October 11, 2002 7:24 AM
To: [EMAIL PROTECTED]
Subject: RE: [mfg-smartcam] rapid to clearance plane


Are you turning off the clearance for the element both before and after the
rapid move?

=============================================
Fred Lauzus, CAM Programming Coordinator
High Steel Structures, Incorporated
mailto:[EMAIL PROTECTED] http://www.highsteel.com
=============================================




-----Original Message-----
From: Pete Ruehle [mailto:[EMAIL PROTECTED]]
Sent: Thursday, October 10, 2002 4:45 PM
To: 'SmartCam Forum'
Subject: [mfg-smartcam] rapid to clearance plane


What method(s) can I use to prevent an end mill from retracting to the
clearance plane before a rapid (G0) move?  I've tried turning off clearance
but I think the cg is forcing it.

Thanks,
Pete
======================================================================
To find out more about this mailing list including how to unsubscribe,
send the message "info mfg-smartcam" to [EMAIL PROTECTED]
======================================================================
======================================================================
To find out more about this mailing list including how to unsubscribe,
send the message "info mfg-smartcam" to [EMAIL PROTECTED]
======================================================================
======================================================================
To find out more about this mailing list including how to unsubscribe,
send the message "info mfg-smartcam" to [EMAIL PROTECTED]
======================================================================

Reply via email to