Michael, Not sure about Q.1!
For custom tools in Show-Cut draw half the tool shape, starting at X0 Y0, in the X+ Y+ quadrant, all on layer 1, as a continuous profile. Regards, Bill in the UK. ----- Original Message ----- From: "Michael R. Deren" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Tuesday, July 29, 2003 2:18 PM Subject: [mfg-smartcam] Modifying arcs and custom tools > Two questions to the group: > 1. If I have a group of arcs that are the same diameter, can I change all of > them at the same time to another diameter? > 2. Is there a way to generate custom cutting tooling in SmartCam so it > displays in Show Cut? > We use FreeForm 11.0. > Thanks in advance, > Mike Deren > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== > > > > ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
