[mfg-smartcam] BLOCK SKIPS

[Jeff]

Fred,   I normally run two parts at a time in our tombstones, one on top and one on bottom. During setup the operators turn on the block skip feature to ignore the bottom part and only run the setup piece. So in the model I would have a series of holes with say 3 differant tools as follows. I would have to insert the block skip manually after the set of all the top holes. It's not that big of a deal except alot of our jobs use over 60 tools so now I have to manually insert alot of block skips. I was curious if I could group the holes in the top part and then run a macro to insert the #BLKDEL=1 after each set of top holes. I hope I explained this better for everyone to understand. I tried making my own but kept getting errors.   Jeff   7 HOLE  (TOP) 8 HOLE  (TOP) 9 HOLE  (TOP) 10 HOLE (BOTTOM) 11 HOLE (BOTTOM) 12 HOLE (BOTTOM) 13 HOLE  (TOP) 14 HOLE  (TOP) 15 HOLE  (TOP) 16 HOLE (BOTTOM) 17 HOLE (BOTTOM) 18 HOLE (BOTTOM) 19 HOLE  (TOP) 20 HOLE  (TOP) 21 HOLE  (TOP) 22 HOLE (BOTTOM) 23 HOLE (BOTTOM) 24 HOLE (BOTTOM)