How can I control the rough pocket routine better. I use layer as boundary ( even though I know that a step boundary seems to work better).
I always use spiral out but when I ask for 45 deg entry it sometimes sticks in small helical moves. These are not in tight areas. I also get three feed rates sometimes. If I set the rough milling parameter to F100 and F50. plunge I also get a F25. from z clr to the Prof top? I think this is from using layer instead of step as a boundary. I also end up with uncut areas unless I make width of cut smaller. Ed Doherty PGMNE - CNC Programming ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
