Dave, Your numbers are pretty close to what we came up with by trial and error. At least we are on the same page with this material. Its really not too bad to machine, but it does wear on the cutters if you push it too hard.
Thanks again, Chris -----Original Message----- From: Dave Wolfgang [mailto:[EMAIL PROTECTED] Sent: Tuesday, May 04, 2004 1:10 PM To: [EMAIL PROTECTED]; [EMAIL PROTECTED] Subject: Re: [mfg-smartcam] machining recommendations If in the same group as Hot Work Tool Steels 200-250 Bhn. 50 fpm hss drilling 1/16 .001 ipr 1/8 .002 ipr 1/4 .003 ipr 1/2 .006 ipr 3/4 .008 ipr 1.0 .010 ipr End Milling Peripheral .020 doc 360 fpm .001in/tooth @ 3/8 dia. .060 doc 270 fpm .0025in/tooth @ 1/2 dia. End Milling Slotting Axial doc .030 50 fpm hss Axial doc .125 45 fpm hss dia/2 40 fpm hss That's the best I can come up with Dave Wolfgang CNC Programmer/Supervisor www.hrindustries.net ----- Original Message ----- From: <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]>; <[EMAIL PROTECTED]>; <[EMAIL PROTECTED]> Sent: Monday, May 03, 2004 1:20 PM Subject: RE: [mfg-smartcam] machining recommendations > That's why I'm asking -- I've never even heard of this material until now. > > Here's a link I found (gives specs, but no machining data): > www.ghcook.com/2714new.htm > > > Chris > > -----Original Message----- > From: Dave Wolfgang [mailto:[EMAIL PROTECTED] > Sent: Monday, May 03, 2004 11:24 AM > To: [EMAIL PROTECTED]; [EMAIL PROTECTED] > Subject: Re: [mfg-smartcam] machining recommendations > > > Need more info! > Can't find that material in my book. > > Dave Wolfgang > CNC Programmer/Supervisor > www.hrindustries.net > > ----- Original Message ----- > From: <[EMAIL PROTECTED]> > To: <[EMAIL PROTECTED]> > Sent: Friday, April 30, 2004 10:52 AM > Subject: [mfg-smartcam] machining recommendations > > > > Hi all, > > > > We are machining some 2714 steel; drilling, slotting, and t-slotting. It > > seems to be a somewhat tough material to machine. Can any one recommend > sfm > > and feed per tooth for hss drills, and also Ingersoll high-positive > inserted > > end mills or an equivalent? Our inserts are ticn coated. > > > > Regards, > > > > Chris Kocourek > > Tool Designer > > FLEXTRONICS CTC > > > > ====================================================================== > > To find out more about this mailing list including how to unsubscribe, > > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > > ====================================================================== > > > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== > ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
