I cleaned up all the oil and will have to inspect the engine for the leak
again. If it does turn out to be a head gasket (there was some oil around
the bottom of the head on the leaky oil filler cap side) do you just
re-torque the bolts or is it more involved than that?


On Sat, Jun 21, 2008 at 12:43 PM, Bill Cardell <[EMAIL PROTECTED]> wrote:

>  FWIW, we find most "leaking" rear mains really aren't. It is usually the
> CAS o-ring running all the way down, or occasionally a head gasket (if a
> 1.6). Pretty sure we've never seen a rear main brg fail by itself. I agree
> with Ray that a failing rear main brg would cause the seal to fail, just
> don't recall seeing it happen on a Miata.
>
>
> Bill Cardell
> TurboDog's Dad
> www.flyinmiata.com
> www.fmwestfield.com
> orders 1-800-FLY-MX5S
> Before you call our tech line (970.464.5600) please check out the 
> *FAQ*<http://www.flyinmiata.com/FAQ/>section of our website
>
> Don't miss Flyin' Miata's Open House! Aug 14-17, 2008
>
>
>  ------------------------------
> *From:* [EMAIL PROTECTED] [mailto:
> [EMAIL PROTECTED] *On Behalf Of *Ray Ayala
> *Sent:* Saturday, June 21, 2008 10:04 AM
> *To:* Robert McElwee
> *Cc:* miatapower List
>
> *Subject:* Re: Tips for Installing a new rear main seal ???
>
>  Changing the main bearings, any of them, requires pulling the pan.  Once
> that's off you might as well replace all of the main and rod bearings
> because they're all probably equally worn.  It's always possible though
> rather unlikely that the rear seal was just defective, and it can be changed
> when the flywheel is off.  And while the trans is out its also easy measure
> how far the crank can move in a the fore/aft direction to check the thrust
> bearing wear ... a separate possible (and  fairly common) problem.
>
> ----- Original Message -----
> *From:* Robert McElwee <[EMAIL PROTECTED]>
> *To:* Ray Ayala <[EMAIL PROTECTED]>
> *Cc:* miatapower List <[email protected]>
> *Sent:* Friday, June 20, 2008 9:47 PM
> *Subject:* Re: Tips for Installing a new rear main seal ???
>
> Hmmm, how do I know if the bearing is gone? After changing the clutch/pilot
> a few years ago I immediately started getting a slight  "bearing noise"
> while decelerating. I haven't noticed it much lately but I am sure it is
> still there.
>
> The car has 105K miles on it and started leaking about 5K (6 months) ago. I
> am not a gear head and not exactly sure what changing the rear main bearing
> entails. Is this something that can/should be done when I change this seal.
>
>
> On Sat, Jun 21, 2008 at 12:38 AM, Ray Ayala <[EMAIL PROTECTED]> wrote:
>
>>  FWIW (and YMMV) rear engine seals don't usually go bad until prompted to
>> by a worn out rear main bearing.
>>
>>  ----- Original Message -----
>> *From:* Robert McElwee <[EMAIL PROTECTED]>
>>   *To:* Ray Ayala <[EMAIL PROTECTED]>
>> *Cc:* miatapower List <[email protected]>
>> *Sent:* Friday, June 20, 2008 9:20 PM
>> *Subject:* Re: Tips for Installing a new rear main seal ???
>>
>> Rear engine seal (I hope). Oil coming from the weep hole in the bell
>> housing. I'm half a quart down right now on the engine oil so I am assuming
>> that is it. I guess we will find out when we pull it.
>>
>> Definitely not CAS o-ring (recently replaced) due to the weep hole leak.
>>
>> On Fri, Jun 20, 2008 at 10:46 PM, Ray Ayala <[EMAIL PROTECTED]> wrote:
>>
>>>  Rear engine seal or front trans seal?   (or CAS o-ring?)
>>>
>>>  ----- Original Message -----
>>> *From:* Robert McElwee <[EMAIL PROTECTED]>
>>> *To:* miatapower List <[email protected]>
>>> *Sent:* Friday, June 20, 2008 2:07 PM
>>> *Subject:* Tips for Installing a new rear main seal ???
>>>
>>>  My oil leak is getting a little worse and I think I am close to pulling
>>> the seal and replacing it. I have had a new seal laying around forever but
>>> have been too lazy to pull the tranny and do the work. I know how to pull
>>> the tranny but anyone have tip for pulling the seal or replacing it?  Just
>>> looking for any little tricks you guys may have up your sleeve...
>>>
>>>
>>> --
>>> Robert McElwee and Blue Flash
>>> "The 40 MPG Miata"
>>> www.lightweightmiata.com/mpg
>>>
>>> Lightweight Miata Forum:
>>> www.lightweightmiata.com/forum
>>>
>>> The Miata Trailer Project:
>>> www.lightweightmiata.com/trailer
>>>
>>> ------------------------------
>>>
>>> _______________________________________________
>>> Miatapower mailing list
>>> [email protected]
>>> http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower
>>>
>>>
>>
>>
>> --
>> Robert McElwee and Blue Flash
>> "The 40 MPG Miata"
>> www.lightweightmiata.com/mpg
>>
>> Lightweight Miata Forum:
>> www.lightweightmiata.com/forum
>>
>> The Miata Trailer Project:
>> www.lightweightmiata.com/trailer
>>
>>
>
>
> --
> Robert McElwee and Blue Flash
> "The 40 MPG Miata"
> www.lightweightmiata.com/mpg
>
> Lightweight Miata Forum:
> www.lightweightmiata.com/forum
>
> The Miata Trailer Project:
> www.lightweightmiata.com/trailer
>
>


-- 
Robert McElwee and Blue Flash
"The 40 MPG Miata"
www.lightweightmiata.com/mpg

Lightweight Miata Forum:
www.lightweightmiata.com/forum

The Miata Trailer Project:
www.lightweightmiata.com/trailer
_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower

Reply via email to