We run PPPoE server on many of our Mikrotik towers. Normally they run
just great. But there is the occasional site that just gives us hell
(Newegg.com and certain secure sites). It only seems to be a problem
when I have a Mikrotik CPE doing PPPoE Client. I've tried just about
every setting I can think of. The AP's with PPPoE server is setup with
the following config:
Server: 2.9.51
/ interface pppoe-server server
add service-name="pppoe-service" interface=sector-pppoe max-mtu=1480 \
max-mru=1480 authentication=pap,chap keepalive-timeout=10 \
one-session-per-host=no max-sessions=0 default-profile=pppoe-profile \
disabled=no
/ ppp profile
add name="pppoe-profile" local-address=x.x.68.1 remote-address=pppoe-pool \
use-compression=yes use-vj-compression=no use-encryption=yes \
only-one=default change-tcp-mss=yes comment=""
The CPE setup (3.7):
/interface pppoe-client
add ac-name="" add-default-route=yes allow=pap,chap comment=""
dial-on-demand=no disabled=no interface=wlan1 max-mru=1400 \
max-mtu=1400 mrru=disabled name="pppoe-out1" password="gump"
profile=default service-name="" use-peer-dns=no \
user="bubba"
/ppp profile
set default change-tcp-mss=yes comment="" name="default"
only-one=default use-compression=default use-encryption=default \
use-vj-compression=default
I have tried MTU/MRU at 1460, 1450, 1440, 1420 also. I don't seem to
have this problem on Deliberant CPE's. I have another customer that
is using a Mikrotik router on a DSL connection. When we do PPPoE on the
routerboard, I run into the same problem. When we let the DSL modem do
pppoE then we are good (unfortunately, I need the Tik box doing PPPoE
client). Is there a problem with my config?
Eric
Eric
