With that being the case take note if you have to replace the board and do a backup/restore!
On 11/7/08, Butch Evans <[EMAIL PROTECTED]> wrote: > On Fri, 7 Nov 2008, Craig Baird wrote: > >>I've got something weird going on. I just configured an RB532 with >>the RB564 daugterboard. Here's what I'm seeing: >> >>This is very confusing when trying to figure out which port to >>physically plug various cables into. I've tried resetting the >>config, but it didn't change anything. Any suggestions on what I >>can do to get the port ordering straightened back out? > > This is a common issue. The only "fix" is to rename the interfaces. > It is a problem that I know MT has been told about, but they did > not, could not or would not (take your pick) change the behaviour. > > -- > ******************************************************************** > * Butch Evans * Professional Network Consultation* > * http://www.butchevans.com/ * Network Engineering * > * http://www.wispa.org/ * WISPA Board Member * > * http://blog.butchevans.com/ * Wired or Wireless Networks * > ******************************************************************** > _______________________________________________ > Mikrotik mailing list > Mikrotik@mail.butchevans.com > http://www.butchevans.com/mailman/listinfo/mikrotik > -- Sent from my mobile device Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 Those who don't understand UNIX are condemned to reinvent it, poorly. --- Henry Spencer