I'm certain I'm using the right cabling. Right now my ifconfig -a displays:
xl0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500 lladdr 00:10:4b:24:40:a0 media: Ethernet autoselect (100baseTX full-duplex) status: active inet 192.168.3.1 netmask 0xffffff00 broadcast 192.168.3.255 inet6 fe80::210:4bff:fe24:40a0%xl0 prefixlen 64 scopeid 0x1 which is my original NIC. As you can see I no longer have the interface of mac address 00:60:08:0d: 8c:4c (previously xl0) But why would the system act like this in the first place????? On Sun, 1 May 2005 16:08:05 +0200, Rogier Krieger wrote > On 5/1/05, Monah Baki <[EMAIL PROTECTED]> wrote: > > I decided to add another interface xl1. > > All of a sudden I get the following error: > > Are you sure that the correct cable leads to the correct interface? > OpenBSD may very well detect the cards in an order different from > what you expect. In other words: xl1 may or may not be the newly > added card. > > > xl1: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500 > <snip> > > status: no carrier > > inet 192.168.3.1 netmask 0xffffff00 broadcast 192.168.3.255 > <snip> > > all my internal computers can't ping 192.168.3.1. > > Which is hardly surprising, considering the system does not detect a > carrier on xl1 as it does on xl0. Verify that the cables and > interfaces match. > > Hope this helps, > > Rogier > > -- > If you don't know where you're going, any road will get you there.