Johan Fredin wrote: > Hello people > > I've recently baught myself one of these small little WRAP boards > (http://www.pcengines.ch/wrap.htm), soekris-look-alike. After > installing -current on it, I noticed the following:
I've noticed this with OpenBSD 3.5 as well and probably it was there in earlier versions...I'd ignore it. > > ------ > # dhclient sis0 > DHCPDISCOVER on sis0 to 255.255.255.255 port 67 interval 6 > ip length 328 disagrees with bytes received 332. > accepting packet with data after udp payload. > DHCPOFFER from 10.0.0.1 > > DHCPREQUEST on sis0 to 255.255.255.255 port 67 > ip length 328 disagrees with bytes received 332. > accepting packet with data after udp payload. > DHCPACK from 10.0.0.1 > bound to 10.0.0.23 -- renewal in 10800 seconds. > ------ > > Looking though the archives I found these posts: > > http://marc.theaimsgroup.com/?l=openbsd-misc&m=106059883119865 > http://marc.theaimsgroup.com/?l=openbsd-tech&m=105760910331290 > > The patch in the last post seems to have been applied already. I > remember that nsphyter was added recently, could that have anything to > do with this? > > Everything works, I just reacted on the "disagrees with bytes" part. > IPv6 via rtsol works aswell, as I saw that Paul de Weerd in the last > post had problems with that. Just wanted to inform you, in case this > is a driver bug. > > Full dmesg below. > > /Johan > > OpenBSD 3.7-current (GENERIC) #110: Mon May 2 20:07:58 MDT 2005 > [EMAIL PROTECTED]:/usr/src/sys/arch/i386/compile/GENERIC > RTC BIOS diagnostic error 80<clock_battery> > cpu0: Geode(TM) Integrated Processor by National Semi ("Geode by NSC" > 586-class) 267 MHz > cpu0: FPU,TSC,MSR,CX8,CMOV,MMX > cpu0: TSC disabled > real mem = 133804032 (130668K) > avail mem = 115552256 (112844K) > using 1658 buffers containing 6791168 bytes (6632K) of memory > RTC BIOS diagnostic error 80<clock_battery> > mainbus0 (root) > bios0 at mainbus0: AT/286+(ac) BIOS, date 07/13/04, BIOS32 rev. 0 @ > 0xfc554 > pcibios0 at bios0: rev 2.1 @ 0xf0000/0x10000 > pcibios0: pcibios_get_intr_routing - function not supported > pcibios0: PCI IRQ Routing information unavailable. > pcibios0: PCI bus #0 is the last bus > cpu0 at mainbus0 > pci0 at mainbus0 bus 0: configuration mode 1 (bios) > pchb0 at pci0 dev 0 function 0 "Cyrix GXm PCI" rev 0x00 > sis0 at pci0 dev 14 function 0 "NS DP83815 10/100" rev 0x00: DP83816A, > irq 10, address 00:0d:b9:01:20:04 > nsphyter0 at sis0 phy 0: DP83815 10/100 PHY, rev. 1 > sis1 at pci0 dev 15 function 0 "NS DP83815 10/100" rev 0x00: DP83816A, > irq 9, address 00:0d:b9:01:20:05 > nsphyter1 at sis1 phy 0: DP83815 10/100 PHY, rev. 1 > sis2 at pci0 dev 16 function 0 "NS DP83815 10/100" rev 0x00: DP83816A, > irq 11, address 00:0d:b9:01:20:06 > nsphyter2 at sis2 phy 0: DP83815 10/100 PHY, rev. 1 > gscpcib0 at pci0 dev 18 function 0 "NS SC1100 ISA" rev 0x00 > gpio0 at gscpcib0: 64 pins > "NS SC1100 SMI/ACPI" rev 0x00 at pci0 dev 18 function 1 not configured > pciide0 at pci0 dev 18 function 2 "NS SCx200 IDE" rev 0x01: DMA, > channel 0 wired to compatibility, channel 1 wired to compatibility > wd0 at pciide0 channel 0 drive 0: <SanDisk SDCFH-256> > wd0: 1-sector PIO, LBA, 245MB, 501760 sectors > wd0(pciide0:0:0): using PIO mode 4, DMA mode 2 > "NS SCx200 AUDIO" rev 0x00 at pci0 dev 18 function 3 not configured > geodesc0 at pci0 dev 18 function 5 "NS SC1100 X-Bus" rev 0x00: iid 6 > revision 3 wdstatus 0 > isa0 at gscpcib0 > isadma0 at isa0 > pcppi0 at isa0 port 0x61 > midi0 at pcppi0: <PC speaker> > sysbeep0 at pcppi0 > gscsio0 at isa0 port 0x2e/2: SC1100 SIO rev 1: ACB1 ACB2 > iic0 at gscsio0 > iic1 at gscsio0 > lmtemp0 at iic1 addr 0x48: LM77 > npx0 at isa0 port 0xf0/16: using exception 16 > pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo > pccom0: console > pccom1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo > biomask f1e7 netmask ffe7 ttymask ffe7 > pctr: no performance counters in CPU > nvram: invalid checksum > dkcsum: wd0 matched BIOS disk 80 > root on wd0a > rootdev=0x0 rrootdev=0x300 rawdev=0x302 > clock: unknown CMOS layout > WARNING: clock time much less than file system time > WARNING: using file system time > WARNING: CHECK AND RESET THE DATE! [demime 1.01d removed an attachment of type application/pgp-signature which had a name of signature.asc]
