Tomasz Marszal wrote: > You can look in http://firmware.OpenBSD.org/firmware. You can look on the > manufacturers spec if it support OpenBSD, There is a possibility to add > unsupported hardware by compiling its driver in to the kernel if its not > in GENERIC > Although I am not an expert in server hardware i would look in mobo users > manual if there is a jumper for disabling/enabling pcie and in bios. You > didnt told us where the Atheros chip is situated is it on mother board on > pcie card or is it external device. > > Best Regards > Tomek > > If You use laptop You can look for the both sidec of the machine there > shuld be a switch > > You told us it is a chip but no info about where is it s > > On Sat, 23 Jun 2012 17:48:41 +1000, Jonathan Gray <j...@jsg.id.au> wrote: >> On Fri, Jun 22, 2012 at 08:21:10PM -0700, Sha'ul wrote: >>> I can't get the Atheros AR9485WB-EG wireless network adapter >>> working. I think it might be tied into the Atheros AR3012 bluetooth >>> 3.0 and Broadcom wireless utility. Looking at athn(4), is there no >>> support for it? >> >> The kernel can't see the pcie device. Perhaps a pcie hotplug >> event is used along with a rfkill switch. Is there a hardware >> switch to enable/disable wireless on the machine?
If I understand the dmesg (and OpenBSD device drivers) properly: > OpenBSD 5.2-beta (GENERIC.MP) #0: Fri Jun 22 11:44:03 PDT 2012 > sh...@fgsr.vc.shawcable.net:/usr/src/sys/arch/amd64/compile/GENERIC.MP > ... Home built kernel, did the OP make any source modifications ? > ppb4 at pci0 dev 21 function 0 "AMD Hudson-2 PCIE" rev 0x00 > pci5 at ppb4 bus 5 > "Atheros AR9485" rev 0x01 at pci5 dev 0 function 0 not configured > ... There's an "Atheros AR9485" device connected to a PCIe bridge. Being "not configured" meaning that there's currently no driver support for this device. > ... > ugen0 at uhub4 port 1 "Atheros Communications Bluetooth USB Host > Controller" rev 1.10/0.01 addr 2 > ... Something similar here, an "Atheros Communications Bluetooth USB Host Controller" USB device is connected, but being attached to ugen, there's no driver for this device either, at present. (besides, AFAICT there's no bluetooth support anyway)
