Hi
Had similar trouble with an Epson. It was explained to me by the team
that usb printing can go through ulpt or ugen. Though in principle both
could be available, no one has been able to assume the responsibility to
make this always happen. It needs someone with the skill and the will to
do so. The team is small and flat out at all times.
Disable ulpt in the user kernel configurator:
# config -ef /bsd
ukc> disable ulpt
ukc> quit
The kernel will now rebuild without ulpt.
# echo "chown _cups:_saned /dev/ugen0.* /dev/usb0" >>/etc/rc.local
(as suggested in /usr/local/share/doc/pkg-readmes/cups-1.x.xp0)
# reboot
Now set up through cups as normal
Good Luck
Mo
On 2014-06-29 18:32, Julian Andrej wrote:
Hello,
i'm trying to configure my printer with CUPS. I connected the printer
via
USB.
I installed cups and gutenprint, because the printer is supported by
gutenprint.
dmesg output:
ulpt0 at uhub3 port 1 configuration 1 interface 1 "Canon MP620
series"
rev 2.00/1.10 addr 6
ulpt0: using bi-directional mode
I changed the rights of ulpt0: `chmod 0666 /dev/ulpt0`
CUPS backend is recognizing the printer
`/usr/local/libexec/cups/backend/usb`:
DEBUG2: Printer found with device ID:
MFG:Canon;CMD:BJL,BJRaster3,BSCCe,NCCe,PLI;SOJ:TXT01,BJNP2;MDL:MP620
series;CLS:PRINTER;DES:Canon MP620
series;VER:1.100;STA:10;HRI:EU;MSI:DAT,E3,HFSF;PDR:4; Device URI:
usb://Canon
/MP620%20series?serial=16BF3A&interface=1
direct usb://Canon/MP620%20series?serial=16BF3A&interface=1 "Canon
MP620
series"
"Canon MP620 series"
"MFG:Canon;CMD:BJL,BJRaster3,BSCCe,NCCe,PLI;SOJ:TXT01,BJNP2;MDL:MP620
series;CLS:PRINTER;DES:Canon MP620
series;VER:1.100;STA:10;HRI:EU;MSI:DAT,E3,HFSF;PDR:4;" ""
In the webinterface the printer does not show up. The printer works
with
Debian Linux
with CUPS and gutenprint.
The Scanner (its a multifunction device) works without configuration
with
xsane.
