I can't tell from your output, are your BGP neighbors more than one hop
away? If so you will need to add a static route to each neighbor before
it will start filling in the local routing table.
If that doesn't work, could you give us excerpts of the bgpd.conf file
and a rough overview of your routing topology?
Thanks,
Bill
On 5/13/2015 8:58 AM, Motty Cruz wrote:
running the command "route show" does not get the full internet
routing table as I should. However, if I run "bgpctl show rib" I get
the full routing table. Router is routing packets fine, however, I am
concern that something may be wrong.
any explanation as to why this is happening?
# bgpctl show
Neighbor AS MsgRcvd MsgSent OutQ Up/Down
State/PrfRcvd
level2 7X32 100853 278 0
02:17:31 532191
level1 7X32 300 278 0
02:17:16 1
gateway2 22X8 274 272 0
02:15:01 1
gateway1 22X8 274 272 0
02:15:01 1
#netstat -rn
Routing tables
Internet:
Destination Gateway Flags Refs Use Mtu Prio
Iface
default 19.25.16.13 UGS 1 8485 - 8 em0
19.25.16.12/30 link#1 UC 1 0 - 4 em0
19.25.16.13 2c:6b:f5:a4:df:40 UHLc 2 583 - 4 em0
127/8 127.0.0.1 UGRS 0 0 33192
8 lo0
127.0.0.1 127.0.0.1 UH 1 0 33192
4 lo0
19.16.26/24 199.96.38.85 UGS 0 882702 - 8 em1
Thanks,
