On Thu, Feb 08, 2018 at 02:31:31PM +0500, ?????????????? ???????????????? wrote: > I install OpenBSD on my Fastwell CPB905 Singleboard compter. IT have > 4-RS-232 port on same IRQ, but on different address on isa bus. Then i > setup only one port using configure command all ports work normally. But > when i setup 2 of them in one boot configuration i get in dmesg: irq > already in use. I found next thing in OpenBSD 3.8. documentation:
Oh please, OpenBSD 3.8 was released November 1, 2005. It was a supported release until OpenBSD 4.0 hit on November 1, 2006. If you want any help at all, *please* get hold of a still-supported release (6.1 or 6.2, or even a -current snapshot) and see what happens when you expose your hardware to that. - Peter -- Peter N. M. Hansteen, member of the first RFC 1149 implementation team http://bsdly.blogspot.com/ http://www.bsdly.net/ http://www.nuug.no/ "Remember to set the evil bit on all malicious network traffic" delilah spamd[29949]: 85.152.224.147: disconnected after 42673 seconds.