Flashrom isn't part of OpenBSD. >I'm trying update BIOS on alix2d13 board with flashrom ver 1.0 on OpenBSD 6.5 > ># flashrom -w alix1.bin -p internal >flashrom v1.0 on OpenBSD 6.5 (i386) >flashrom is free software, get the source code at https://flashrom.org > >Calibrating delay loop... delay loop is unreliable, trying to continue OK. >No DMI table found. >Found chipset "AMD CS5536". >Enabling flash write... Error while opening /dev/amdmsr: Device not configured >FAILED! >Warning: unexpected second chipset match: "AMD CS5536" >ignoring, please report lspci and board URL to flash...@flashrom.org >with 'CHIPSET: your board name' in the subject line. >No EEPROM/flash device found. >Note: flashrom can never write if the flash chip isn't found automatically. > >What's wrong? > >dmesg: > >OpenBSD 6.5 (GENERIC) #1: Wed Apr 24 22:04:27 CEST 2019 > r...@syspatch-65-i386.openbsd.org:/usr/src/sys/arch/i386/compile/GENERIC >real mem = 267931648 (255MB) >avail mem = 247779328 (236MB) >mpath0 at root >scsibus0 at mpath0: 256 targets >mainbus0 at root >bios0 at mainbus0: date 11/05/08, BIOS32 rev. 0 @ 0xfd088 >pcibios0 at bios0: rev 2.1 @ 0xf0000/0x10000 >pcibios0: pcibios_get_intr_routing - function not supported >pcibios0: PCI IRQ Routing information unavailable. >pcibios0: PCI bus #0 is the last bus >bios0: ROM list: 0xe0000/0xa800 >cpu0 at mainbus0: (uniprocessor) >cpu0: Geode(TM) Integrated Processor by AMD PCS ("AuthenticAMD" 586-class) 499 >MHz, 05-0a-02 >cpu0: FPU,DE,PSE,TSC,MSR,CX8,SEP,PGE,CMOV,CFLUSH,MMX,MMXX,3DNOW2,3DNOW >mtrr: K6-family MTRR support (2 registers) >pci0 at mainbus0 bus 0: configuration mode 1 (bios) >pchb0 at pci0 dev 1 function 0 "AMD Geode LX" rev 0x33 >glxsb0 at pci0 dev 1 function 2 "AMD Geode LX Crypto" rev 0x00: RNG AES >vr0 at pci0 dev 9 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 10, address >00:0d:b9:2b:d9:3c >ukphy0 at vr0 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI >0x004063, model 0x0034 >vr1 at pci0 dev 10 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 11, address >00:0d:b9:2b:d9:3d >ukphy1 at vr1 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI >0x004063, model 0x0034 >vr2 at pci0 dev 11 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 15, address >00:0d:b9:2b:d9:3e >ukphy2 at vr2 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI >0x004063, model 0x0034 >athn0 at pci0 dev 12 function 0 "Atheros AR9280" rev 0x01: irq 9 >athn0: AR9280 rev 2 (2T2R), ROM rev 21, address a8:54:b2:3e:02:e7 >glxpcib0 at pci0 dev 15 function 0 "AMD CS5536 ISA" rev 0x03: rev 3, 32-bit >3579545Hz timer, watchdog, gpio, i2c >gpio0 at glxpcib0: 32 pins >iic0 at glxpcib0 >maxtmp0 at iic0 addr 0x4c: lm86 >pciide0 at pci0 dev 15 function 2 "AMD CS5536 IDE" rev 0x01: DMA, channel 0 >wired to compatibility, channel 1 wired to compatibility >wd0 at pciide0 channel 0 drive 0: <CF 16GB> >wd0: 1-sector PIO, LBA, 15279MB, 31293360 sectors >wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 2 >pciide0: channel 1 ignored (disabled) >ohci0 at pci0 dev 15 function 4 "AMD CS5536 USB" rev 0x02: irq 12, version >1.0, legacy support >ehci0 at pci0 dev 15 function 5 "AMD CS5536 USB" rev 0x02: irq 12 >usb0 at ehci0: USB revision 2.0 >uhub0 at usb0 configuration 1 interface 0 "AMD EHCI root hub" rev 2.00/1.00 >addr 1 >isa0 at glxpcib0 >isadma0 at isa0 >com0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo >com0: console >com1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo >pcppi0 at isa0 port 0x61 >spkr0 at pcppi0 >npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16 >usb1 at ohci0: USB revision 1.0 >uhub1 at usb1 configuration 1 interface 0 "AMD OHCI root hub" rev 1.00/1.00 >addr 1 >nvram: invalid checksum >vscsi0 at root >scsibus1 at vscsi0: 256 targets >softraid0 at root >scsibus2 at softraid0: 256 targets >root on wd0a (93235fc23433e834.a) swap on wd0b dump on wd0b >clock: unknown CMOS layout >
-- ¯\_(ツ)_/¯ ¯\_(ツ)_/¯
