Hello, umsm is not being detected on this machine for Huawei E303 modem. Only interface 0 and 1 which are both umass are detected. interface 2 is umsm but not active please see boot message.
Any guidance here is highly appreciated. Kihaguru. Jun 29 13:14:37 GMT 2019 PowerOn SelfTest start POST:Testing Flash/SRAM POST:Testing SC POST:Testing XSCF POST:Banner POST:FATAL check POST:Testing Timer1 POST:Testing Tick POST:Testing MMU POST:Testing CPU Type POST:Testing DTAG POST:Memory Probe POST:Testing Memory POST:Testing Softint POST:Testing U2P POST:Testing Slave Device POST:Testing Master Device POST:System Configure POST:OBP Start screen not found. keyboard not found. Keyboard not present. Using ttya for input and output. Fujitsu Siemens PRIMEPOWER250 2x SPARC64 V, No Keyboard OpenBoot 3.18.1-1, 16384 MB memory installed Ethernet address 0:b:5d:f3:a7:5c, Host ID: 80f2a75c. XSCF Version: 4.12.1 {0} ok boot Boot device: /pci@83,4000/FJSV,ulsa@2,1/disk@0,0 File and args: OpenBSD IEEE 1275 Bootblock 1.4 ..>> OpenBSD BOOT 1.11 Can't read disk label. Can't open disk label package Trying bsd... Booting /pci@83,4000/FJSV,ulsa@2,1/disk@0,0:a/bsd 9453456@0x1000000+112@0x1903f90+202800@0x1c00000+3991504@0x1c31830 symbols @ 0xfe9e2400 165+610944+416267 start=0x1000000 [ using 1028408 bytes of bsd ELF symbol table ] console is /pci@83,4000/isa@7/su@0,3f8 Copyright (c) 1982, 1986, 1989, 1991, 1993 The Regents of the University of California. All rights reserved. Copyright (c) 1995-2018 OpenBSD. All rights reserved. https://www.OpenBSD.org OpenBSD 6.4 (GENERIC.MP) #6: Fri Oct 12 09:57:36 MDT 2018 dera...@sparc64.openbsd.org:/usr/src/sys/arch/sparc64/compile/GENERIC.MP real mem = 17179869184 (16384MB) avail mem = 16862707712 (16081MB) mpath0 at root scsibus0 at mpath0: 256 targets mainbus0 at root: Fujitsu Siemens PRIMEPOWER250 2x SPARC64 V cpu0 at mainbus0: FJSV,SPARC64-V (rev 5.1) @ 1979 MHz cpu0: physical 128K instruction (64 b/l), 128K data (64 b/l), 3072K external (64 b/l) cpu1 at mainbus0: FJSV,SPARC64-V (rev 5.1) @ 1979 MHz cpu1: physical 128K instruction (64 b/l), 128K data (64 b/l), 3072K external (64 b/l) psycho0 at mainbus0 addr 0xfffb2000: SUNW,psycho, impl 0, version 4, ign c0 psycho0: bus range 0-0, PCI bus 0 psycho0: dvma map fe000000-ffffffff, STC0 enabled pci0 at psycho0 ebus0 at pci0 dev 1 function 0 "Sun PCIO EBus2" rev 0x01 "FJSV,scfc" at ebus0 addr 210000-210085, 220000-220031, 260000-260001, 270000-28ffff ivec 0x23 not configured "FJSV,flashprom" at ebus0 addr 0-3fffff not configured clock1 at ebus0 addr 250000-251fff: mk48t59 "FJSV,panel" at ebus0 addr 210011-210011 ivec 0x25 not configured ebus1 at pci0 dev 7 function 0 "Acer Labs M1533 ISA" rev 0x00 com0 at ebus1 addr 3f8-3ff ivec 0x2b: ns16550a, 16 byte fifo com0: console com1 at ebus1 addr 2e8-2ef ivec 0x2b: ns16550a, 16 byte fifo hme0 at pci0 dev 1 function 1 "Sun HME" rev 0x01: ivec 0xe1, address 00:0b:5d:f3:a7:5c nsphyter0 at hme0 phy 1: DP83843 10/100 PHY, rev. 0 mpi0 at pci0 dev 2 function 1 "Symbios Logic 53c1030" rev 0x07: ivec 0xe0 mpi0: 0, firmware 1.0.12.0 scsibus1 at mpi0: 16 targets, initiator 7 sym0 at scsibus1 targ 0 lun 0: <FUJITSU, MAT3073N SUN72G, 0602> SCSI2 0/direct fixed serial.FUJITSU_MAT3073N_SUN72G_000506B00RAR_AAN0P5200RAR sd0 at scsibus0 targ 0 lun 0: <FUJITSU, MAT3073N SUN72G, 0602> SCSI2 0/direct fixed serial.FUJITSU_MAT3073N_SUN72G_000506B00RAR_AAN0P5200RAR sd0: 70007MB, 512 bytes/sector, 143374738 sectors sym1 at scsibus1 targ 1 lun 0: <FUJITSU, MAT3073N SUN72G, 0602> SCSI2 0/direct fixed serial.FUJITSU_MAT3073N_SUN72G_000506B00SSL_AAN0P5200SSL sd1 at scsibus0 targ 1 lun 0: <FUJITSU, MAT3073N SUN72G, 0602> SCSI2 0/direct fixed serial.FUJITSU_MAT3073N_SUN72G_000506B00SSL_AAN0P5200SSL sd1: 70007MB, 512 bytes/sector, 143374738 sectors mpi0: target 0 Sync at 160MHz width 16bit offset 127 QAS 1 DT 1 IU 1 mpi0: target 1 Sync at 160MHz width 16bit offset 127 QAS 1 DT 1 IU 1 pciide0 at pci0 dev 13 function 0 "Acer Labs M5229 UDMA IDE" rev 0xc4: DMA, channel 0 configured to native-PCI, channel 1 configured to native-PCI pciide0: using ivec 0xe4 for native-PCI interrupt atapiscsi0 at pciide0 channel 0 drive 0 scsibus2 at atapiscsi0: 2 targets cd0 at scsibus2 targ 0 lun 0: <MATSHITA, DVD-ROM SR-8178, PY28> ATAPI 5/cdrom removable cd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 2 pciide0: channel 1 disabled (no drives) ohci0 at pci0 dev 10 function 0 "Acer Labs M5237 USB" rev 0x03: ivec 0xe9, version 1.0, legacy support usb0 at ohci0: USB revision 1.0 uhub0 at usb0 configuration 1 interface 0 "Acer Labs OHCI root hub" rev 1.00/1.00 addr 1 psycho1 at mainbus0 addr 0xfff9e000: SUNW,psycho, impl 0, version 4, ign c0 psycho1: bus range 128-128, PCI bus 128 psycho1: dvma map fe000000-ffffffff, STC0 enabled, STC1 enabled pci1 at psycho1 bge0 at pci1 dev 1 function 0 "Fujitsu PRIMEPOWER250/450 LAN" rev 0x02, BCM5702/5703 A2 (0x1002): ivec 0xc0, address 00:0b:5d:f4:27:5c brgphy0 at bge0 phy 1: BCM5703 10/100/1000baseT PHY, rev. 2 "counter-timer" at mainbus0 addr 0xfff8bc00 not configured umass0 at uhub0 port 2 configuration 1 interface 0 "HUAWEI HUAWEI Mobile" rev 2.00/1.02 addr 2 umass0: using SCSI over Bulk-Only scsibus3 at umass0: 2 targets, initiator 0 cd1 at scsibus3 targ 1 lun 0: <HUAWEI, Mass Storage, 2.31> SCSI2 5/cdrom removable umass1 at uhub0 port 2 configuration 1 interface 1 "HUAWEI HUAWEI Mobile" rev 2.00/1.02 addr 2 umass1: using SCSI over Bulk-Only scsibus4 at umass1: 2 targets, initiator 0 sd2 at scsibus4 targ 1 lun 0: <HUAWEI, SD Storage, 2.31> SCSI2 0/direct removable vscsi0 at root scsibus5 at vscsi0: 256 targets softraid0 at root scsibus6 at softraid0: 256 targets bootpath: /pci@83,4000/FJSV,ulsa@2,1/disk@0,0 root on sd0a (54b2ae6886d69ea0.a) swap on sd0b dump on sd0b WARNING: / was not properly unmounted Automatic boot in progress: starting file system checks. /dev/sd0a (54b2ae6886d69ea0.a): 1770 files, 32786 used, 482731 free (67 frags, 60333 blocks, 0.0% fragmentation) /dev/sd0a (54b2ae6886d69ea0.a): MARKING FILE SYSTEM CLEAN /dev/sd0k (54b2ae6886d69ea0.k): 11 files, 11 used, 14951367 free (23 frags, 1868918 blocks, 0.0% fragmentation) /dev/sd0k (54b2ae6886d69ea0.k): MARKING FILE SYSTEM CLEAN /dev/sd0d (54b2ae6886d69ea0.d): 4 files, 3 used, 2064474 free (34 frags, 258055 blocks, 0.0% fragmentation) /dev/sd0d (54b2ae6886d69ea0.d): MARKING FILE SYSTEM CLEAN /dev/sd0f (54b2ae6886d69ea0.f): 14031 files, 322148 used, 710535 free (295 frags, 88780 blocks, 0.0% fragmentation) /dev/sd0f (54b2ae6886d69ea0.f): MARKING FILE SYSTEM CLEAN /dev/sd0g (54b2ae6886d69ea0.g): 1 files, 1 used, 515516 free (20 frags, 64437 blocks, 0.0% fragmentation) /dev/sd0g (54b2ae6886d69ea0.g): MARKING FILE SYSTEM CLEAN /dev/sd0h (54b2ae6886d69ea0.h): 108 files, 108 used, 5037029 free (77 frags, 629619 blocks, 0.0% fragmentation) /dev/sd0h (54b2ae6886d69ea0.h): MARKING FILE SYSTEM CLEAN /dev/sd0j (54b2ae6886d69ea0.j): 1 files, 1 used, 3096270 free (14 frags, 387032 blocks, 0.0% fragmentation) /dev/sd0j (54b2ae6886d69ea0.j): MARKING FILE SYSTEM CLEAN /dev/sd0i (54b2ae6886d69ea0.i): 1 files, 1 used, 1032682 free (18 frags, 129083 blocks, 0.0% fragmentation) /dev/sd0i (54b2ae6886d69ea0.i): MARKING FILE SYSTEM CLEAN /dev/sd0e (54b2ae6886d69ea0.e): 131 files, 2081 used, 3959218 free (130 frags, 494886 blocks, 0.0% fragmentation) /dev/sd0e (54b2ae6886d69ea0.e): MARKING FILE SYSTEM CLEAN setting tty flags pf enabled starting network hme0: no link.......... sleeping reordering libraries: done. starting early daemons: syslogd pflogd ntpd. starting RPC daemons:. savecore: no core dump checking quotas: done. clearing /tmp kern.securelevel: 0 -> 1 creating runtime link editor directory cache. preserving editor files. starting network daemons: sshd smtpd httpd sndiod. starting local daemons: cron. Sat Jun 29 16:20:46 EAT 2019 OpenBSD/sparc64 (www.zuku.co.ke) (console) login: