> Hi, > > My PCEngines APU died and I need to rebuild my router. > > I'm throwing together an old desktop, but ultimately I'd like to use a > Raspberry Pi that I bought to play with. > > My network configuration needs 2 wired interfaces. I don't have a switch > that will do vlans, and I don't want to have to configure all of that. > > This is only for a 20 Meg (bi directional) connection, so not stressing > things too much. > > What would be a good USB to ethernet (RJ45) adapter that is supported by > OpenBSD? > > Thanks, > Steve W.
Hi Steve, this bandwidth will be fine even on a RPI3 (tried here on old link, it was fine up to 50Mbps without queuing). I have now a RPI4 4GB and an USB Trendnet usb3 adapter: rpi4_obsd /bsd: axen0 at uhub0 port 3 configuration 1 interface 0 "ASIX Elec. Corp. AX88179" rev 3.00/1.00 addr 3 rpi4_obsd /bsd: axen0: AX88179, address xxxxxxxxxx rpi4_obsd /bsd: rgephy0 at axen0 phy 3: RTL8169S/8110S/8211 PHY, rev. 5 that despite some messages like this: rpi4_obsd /bsd: axen0: checksum err (pkt#1) will do fine. Nowadays the link is 200/80 Mbps and I use queuing fine. For 20Mbps even the usb2 Linksys 100Mbps ethernet will do for you. att, matheus
