Beautiful! Thanks a lot!

But, which FM should I R? I have searched high and low
alas apparently not right.



On Thu, May 03, 2007 at 03:25:20PM +0200, Reyk Floeter wrote:
> hi!
> 
> On Thu, May 03, 2007 at 12:19:01PM +0200, Raimo Niskanen wrote:
> > Aah, here we go again.
> > 
> > I still haven't figured out how to use the iLO remote console.
> > 
> > I have tried ssh towards the iLO IP address and get no connection.
> > 
> > I have tried telnet towards the iLO IP address and get a weird
> > /./-> prompt. Can I do anything useful with it?
> > 
> 
> RTFM ;)
> 
> /./-> cd system1
> 
> /./system1/-> show
>     /./system1
>     Targets
>         log1
>         
>     Properties
>         name=Hewlett-Packard
>         enabledstate=enabled
>         
>     Verbs
>         cd
>         version
>         exit
>         show
>         reset
>         start
>         stop
>         help
>         
> 
> /./system1/-> stop
> System1 stopped.
> 
> /./system1/-> start
> System1 started.
> 
> 
> > I have tried http towards the iLO IP address and get the
> > server virtual power controls, etc, rather flashy, can remote
> > power on, watch temperature sensors. Cool. But no console.
> > 
> > You (or someone) just briefly mentioned Esc-Q. Where is it used?
> > 
> 
> just press ESC-q anywhere at the prompt
> 
> /./-> <ESC-q>
> 
> and you'll get the system console. leave it with ESC-(
> 
> > 
> > 
> > On Thu, May 03, 2007 at 01:41:32AM +0200, Reyk Floeter wrote:
> > > On Wed, May 02, 2007 at 05:41:49PM +0200, Raimo Niskanen wrote:
> > > > I have now spent the entre afternoon on it, but I can not get
> > > > the serial console to work.
> > > > 
> > > >         boot> set tty com0
> > > > gives no prompt anywhere. I have tried many BIOS settings
> > > > (but probably not all).
> > > > 
> > > > Has anyone got it to work?
> > > > 
> > > 
> > > yes, but i'm using it for the iLO remote console, not for the physical
> > > serial interface. it might conflict with the iLO interface, i think
> > > there are some related buttons in the BIOS IPMI/BCM section. 
> > > 
> > > # sysctl hw.product 
> > > hw.product=ProLiant DL145 G3
> > > # grep tty /etc/boot.conf 
> > > set tty com0
> > > # uname -m                                                                
> > >      
> > > amd64
> > > 
> > > reyk
> > 
> > -- 
> > 
> > / Raimo Niskanen, Erlang/OTP, Ericsson AB

-- 

/ Raimo Niskanen, Erlang/OTP, Ericsson AB

Reply via email to