Hi, I'm failing to use vic(4) driver on ESX 3.0.2 and OpenBSD 4.2. I've configured ethernet0.virtualDev = "vmxnet" as instructed on vic(4) man page.
dmesg follows: OpenBSD 4.2 (GENERIC) #1: Fri Oct 12 16:00:29 BRT 2007 [EMAIL PROTECTED]:/usr/src/sys/arch/i386/compile/GENERIC cpu0: Intel(R) Xeon(R) CPU E5310 @ 1.60GHz ("GenuineIntel" 686-class) 1.60 GHz cpu0: FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,CFLUSH,DS,ACPI,MMX,FXSR,SSE,SSE2,SS,SSE3,DS-CPL,CX16 real mem = 1073246208 (1023MB) avail mem = 1030144000 (982MB) mainbus0 at root bios0 at mainbus0: AT/286+ BIOS, date 04/17/06, BIOS32 rev. 0 @ 0xfd880, SMBIOS rev. 2.31 @ 0xe0010 (45 entries) bios0: vendor Phoenix Technologies LTD version "6.00" date 04/17/2006 bios0: VMware, Inc. VMware Virtual Platform apm0 at bios0: Power Management spec V1.2 apm0: AC on, battery charge unknown apm0: flags 30102 dobusy 0 doidle 1 pcibios0 at bios0: rev 2.1 @ 0xfd880/0x780 pcibios0: PCI IRQ Routing Table rev 1.0 @ 0xfdf30/176 (9 entries) pcibios0: PCI Interrupt Router at 000:07:0 ("Intel 82371FB ISA" rev 0x00) pcibios0: PCI bus #1 is the last bus bios0: ROM list: 0xc0000/0x8000 0xc8000/0x1a00! 0xca000/0x1000 0xcb000/0x1000 0xdc000/0x4000! 0xe0000/0x4000! cpu0 at mainbus0 pci0 at mainbus0 bus 0: configuration mode 1 (no bios) pchb0 at pci0 dev 0 function 0 "Intel 82443BX AGP" rev 0x01 ppb0 at pci0 dev 1 function 0 "Intel 82443BX AGP" rev 0x01 pci1 at ppb0 bus 1 piixpcib0 at pci0 dev 7 function 0 "Intel 82371AB PIIX4 ISA" rev 0x08 pciide0 at pci0 dev 7 function 1 "Intel 82371AB IDE" rev 0x01: DMA, channel 0 configured to compatibility, channel 1 configured to c ompatibility atapiscsi0 at pciide0 channel 0 drive 0 scsibus0 at atapiscsi0: 2 targets cd0 at scsibus0 targ 0 lun 0: <NECVMWar, VMware IDE CDR00, 1.00> SCSI0 5/cdrom removable cd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 2 pciide0: channel 1 ignored (disabled) piixpm0 at pci0 dev 7 function 3 "Intel 82371AB Power" rev 0x08: SMBus disabled vga1 at pci0 dev 15 function 0 "VMware Virtual SVGA II" rev 0x00 wsdisplay0 at vga1 mux 1: console (80x25, vt100 emulation) wsdisplay0: screen 1-5 added (80x25, vt100 emulation) mpi0 at pci0 dev 16 function 0 "Symbios Logic 53c1030" rev 0x01: irq 9 scsibus1 at mpi0: 16 targets sd0 at scsibus1 targ 0 lun 0: <VMware, Virtual disk, 1.0> SCSI2 0/direct fixed sd0: 10240MB, 1305 cyl, 255 head, 63 sec, 512 bytes/sec, 20971520 sec total sd1 at scsibus1 targ 1 lun 0: <VMware, Virtual disk, 1.0> SCSI2 0/direct fixed sd1: 20480MB, 2610 cyl, 255 head, 63 sec, 512 bytes/sec, 41943040 sec total mpi0: target 0 Sync at 160MHz width 16bit offset 127 QAS 1 DT 1 IU 1 mpi0: target 1 Sync at 160MHz width 16bit offset 127 QAS 1 DT 1 IU 1 pcn0 at pci0 dev 17 function 0 "AMD 79c970 PCnet-PCI" rev 0x10, Am79c970A, rev 0: irq 11, address 00:50:56:91:57:b6 pcn1 at pci0 dev 18 function 0 "AMD 79c970 PCnet-PCI" rev 0x10, Am79c970A, rev 0: irq 10, address 00:50:56:91:16:e8 isa0 at piixpcib0 isadma0 at isa0 pckbc0 at isa0 port 0x60/5 pckbd0 at pckbc0 (kbd slot) pckbc0: using irq 1 for kbd slot wskbd0 at pckbd0: console keyboard, using wsdisplay0 pmsi0 at pckbc0 (aux slot) pckbc0: using irq 12 for aux slot wsmouse0 at pmsi0 mux 0 pcppi0 at isa0 port 0x61 midi0 at pcppi0: <PC speaker> spkr0 at pcppi0 lpt0 at isa0 port 0x378/4 irq 7 npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16 pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo pccom1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo fdc0 at isa0 port 0x3f0/6 irq 6 drq 2 biomask e365 netmask ef65 ttymask ffe7 pctr: 686-class user-level performance counters enabled mtrr: CPU supports MTRRs but not enabled dkcsum: sd0 matches BIOS drive 0x80 dkcsum: sd1 matches BIOS drive 0x81 root on sd0a swap on sd0b dump on sd0b -- Fernando M. Braga +55 82 8802-9559