Hi, I recently posted in ports some problems I am having with an i386 laptop
http://marc.info/?l=openbsd-ports&m=122191620826430&w=2 and especially http://marc.info/?l=openbsd-ports&m=122189105726930&w=2 Nikolay suggested it could be a hardware problem. To be sure, I made a clean install of the system and the problems (not same, but similar) were still there. Therefore I booted into memtest86 from a linux live CD. The test went fine; then I tried smartcl (messages attached to this message below). It seems that it runs fine but I don't get output from the "long" test... Any hint? I have tried /dev/rwd0c too... but same result. How can I check my problem?? Thanks, Pau andromina# smartctl -i /dev/wd0c zsh: command not found: smartctl andromina# /usr/local/sbin/smartctl -i /dev/wd0c smartctl version 5.37 [i386-unknown-openbsd4.3] Copyright (C) 2002-6 Bruce Allen Home page is http://smartmontools.sourceforge.net/ === START OF INFORMATION SECTION === Model Family: Fujitsu MHT series Device Model: FUJITSU MHT2080AT Serial Number: NN7CT4A15HPM Firmware Version: 0022 User Capacity: 80,026,361,856 bytes Device is: In smartctl database [for details use: -P show] ATA Version is: 6 ATA Standard is: ATA/ATAPI-6 T13 1410D revision 3a Local Time is: Sat Sep 20 15:18:00 2008 CEST SMART support is: Available - device has SMART capability. SMART support is: Enabled andromina# /usr/local/sbin/smartctl -s on -d ata /dev/wd0c smartctl version 5.37 [i386-unknown-openbsd4.3] Copyright (C) 2002-6 Bruce Allen Home page is http://smartmontools.sourceforge.net/ === START OF ENABLE/DISABLE COMMANDS SECTION === SMART Enabled. andromina# /usr/local/sbin/smartctl -d ata -a /dev/wd0c smartctl version 5.37 [i386-unknown-openbsd4.3] Copyright (C) 2002-6 Bruce Allen Home page is http://smartmontools.sourceforge.net/ === START OF INFORMATION SECTION === Model Family: Fujitsu MHT series Device Model: FUJITSU MHT2080AT Serial Number: NN7CT4A15HPM Firmware Version: 0022 User Capacity: 80,026,361,856 bytes Device is: In smartctl database [for details use: -P show] ATA Version is: 6 ATA Standard is: ATA/ATAPI-6 T13 1410D revision 3a Local Time is: Sat Sep 20 15:18:41 2008 CEST SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 587) seconds. Offline data collection capabilities: (0x7b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. No General Purpose Logging support. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 80) minutes. Conveyance self-test routine recommended polling time: ( 2) minutes. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x000f 100 100 046 Pre-fail Always - 41054 2 Throughput_Performance 0x0005 100 100 030 Pre-fail Offline - 31064064 3 Spin_Up_Time 0x0003 100 100 025 Pre-fail Always - 1 4 Start_Stop_Count 0x0032 098 098 000 Old_age Always - 7953 5 Reallocated_Sector_Ct 0x0033 100 100 024 Pre-fail Always - 8589934592000 7 Seek_Error_Rate 0x000f 100 100 047 Pre-fail Always - 3090 8 Seek_Time_Performance 0x0005 100 100 019 Pre-fail Offline - 0 9 Power_On_Seconds 0x0032 085 085 000 Old_age Always - 7692h+39m+26s 10 Spin_Retry_Count 0x0013 100 100 020 Pre-fail Always - 0 12 Power_Cycle_Count 0x0032 099 099 000 Old_age Always - 7522 192 Power-Off_Retract_Count 0x0032 099 099 000 Old_age Always - 373 193 Load_Cycle_Count 0x0032 078 078 000 Old_age Always - 229771 194 Temperature_Celsius 0x0022 100 100 000 Old_age Always - 33 (Lifetime Min/Max 9/44) 195 Hardware_ECC_Recovered 0x001a 100 100 000 Old_age Always - 623 196 Reallocated_Event_Count 0x0032 100 100 000 Old_age Always - 280363008 197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 0 198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 0 199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0 200 Multi_Zone_Error_Rate 0x000f 100 100 060 Pre-fail Always - 3752 203 Run_Out_Cancel 0x0002 100 100 000 Old_age Always - 3732284113101 SMART Error Log Version: 1 No Errors Logged SMART Self-test log structure revision number 1 No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. andromina# /usr/local/sbin/smartctl -d ata -t long /dev/wd0c smartctl version 5.37 [i386-unknown-openbsd4.3] Copyright (C) 2002-6 Bruce Allen Home page is http://smartmontools.sourceforge.net/ === START OF OFFLINE IMMEDIATE AND SELF-TEST SECTION === Sending command: "Execute SMART Extended self-test routine immediately in off-line mode". Drive command "Execute SMART Extended self-test routine immediately in off-line mode" successful. Testing has begun. Please wait 80 minutes for test to complete. Test will complete after Sat Sep 20 16:40:31 2008 Use smartctl -X to abort test. andromina# ps aux | grep smartctl root 24421 0.0 0.1 300 768 p0 S+ 3:24PM 0:00.00 grep smartctl andromina# date Sat Sep 20 16:48:40 CEST 2008
