Hi,
I have just updated from 4.3 to 4.4 on one of my boxes. All has gone
well except for the network device not being left up and running after
the machine has been booted.
The machine is running dhclient with the hostname file just containing
dhcp NONE NONE NONE. During the boot I see messages showing the link
going from up to down followed by down to up, as well as a few dhcp
requests followed by an ack.
ifconfig after a boot shows:
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 33204
groups: lo
inet 127.0.0.1 netmask 0xff000000
inet6 ::1 prefixlen 128
inet6 fe80::1%lo0 prefixlen 64 scopeid 0x3
vge0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
lladdr 00:40:63:e6:d1:ee
groups: egress
media: Ethernet autoselect (none)
status: no carrier
inet6 fe80::240:63ff:fee6:d1ee%vge0 prefixlen 64 scopeid 0x1
inet 192.168.67.40 netmask 0xffffff00 broadcast 192.168.67.255
enc0: flags=0<> mtu 1536
So vge0 appears to be up but no signal is detected on the cable. Weird.
So I do the ifconfig down/up shuffle to see what happens. As soon
as (or very soon afterwards) the down is done ifconfig shows the following:
vge0: flags=8802<BROADCAST,SIMPLEX,MULTICAST> mtu 1500
lladdr 00:40:63:e6:d1:ee
groups: egress
media: Ethernet autoselect (100baseTX full-duplex)
status: active
inet6 fe80::240:63ff:fee6:d1ee%vge0 prefixlen 64 scopeid 0x1
inet 192.168.67.40 netmask 0xffffff00 broadcast 192.168.67.255
So, the device is down but now the line status is active. Do ifconfig
up and then everything is happy and network access happens.
If I change the hostname file to "dhcp media 100baseTX mediaopt
full-duplex" then the interface stays up on boot. So perhaps this is
just an issue with autoselect for this device.
Anyhoo, here is the dmesg:
OpenBSD 4.4 (GENERIC) #1021: Tue Aug 12 17:16:55 MDT 2008
dera...@i386.openbsd.org:/usr/src/sys/arch/i386/compile/GENERIC
cpu0: VIA Esther processor 1500MHz ("CentaurHauls" 686-class) 1.50 GHz
cpu0:
FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,CMOV,PAT,CFLUSH,ACPI,
MMX,FXSR,SSE,SSE2,TM,SBF,SSE3,EST,TM2
cpu0: RNG AES AES-CTR SHA1 SHA256 RSA
real mem = 1039691776 (991MB)
avail mem = 996839424 (950MB)
mainbus0 at root
bios0 at mainbus0: AT/286+ BIOS, date 06/22/06, BIOS32 rev. 0 @ 0xf9360,
SMBIOS
rev. 2.3 @ 0xf0800 (25 entries)
apm0 at bios0: Power Management spec V1.2 (slowidle)
apm0: AC on, battery charge unknown
acpi at bios0 function 0x0 not configured
pcibios0 at bios0: rev 2.1 @ 0xf0000/0xc4f4
pcibios0: PCI IRQ Routing Table rev 1.0 @ 0xfc450/160 (8 entries)
pcibios0: bad IRQ table checksum
pcibios0: PCI BIOS has 8 Interrupt Routing table entries
pcibios0: PCI Exclusive IRQs: 5 10 11
pcibios0: PCI Interrupt Router at 000:17:0 ("VIA VT8237 ISA" rev 0x00)
pcibios0: PCI bus #1 is the last bus
bios0: ROM list: 0xc0000/0xfc00 0xd0000/0x8000! 0xd8000/0x1000
cpu0 at mainbus0
cpu0: unknown Enhanced SpeedStep CPU, msr 0x08100f1308000f13
cpu0: using only highest and lowest power states
cpu0: Enhanced SpeedStep 1500 MHz (1004 mV): speeds: 1500, 800 MHz
pci0 at mainbus0 bus 0: configuration mode 1 (no bios)
pchb0 at pci0 dev 0 function 0 "VIA CN700 Host" rev 0x00
pchb1 at pci0 dev 0 function 1 "VIA CN700 Host" rev 0x00
pchb2 at pci0 dev 0 function 2 "VIA CN700 Host" rev 0x00
pchb3 at pci0 dev 0 function 3 "VIA PT890 Host" rev 0x00
pchb4 at pci0 dev 0 function 4 "VIA CN700 Host" rev 0x00
pchb5 at pci0 dev 0 function 7 "VIA CN700 Host" rev 0x00
ppb0 at pci0 dev 1 function 0 "VIA VT8377 AGP" rev 0x00
pci1 at ppb0 bus 1
vga1 at pci1 dev 0 function 0 "VIA S3 Unichrome PRO IGP" rev 0x01
wsdisplay0 at vga1 mux 1: console (80x25, vt100 emulation)
wsdisplay0: screen 1-5 added (80x25, vt100 emulation)
agp0 at vga1: v3, aperture at 0xf0000000, size 0xf000000
drm at vga1 unsupported
"VIA VT6306 FireWire" rev 0x80 at pci0 dev 13 function 0 not configured
vge0 at pci0 dev 14 function 0 "VIA VT612x" rev 0x11: irq 10, address
00:40:63:e
6:d1:ee
ciphy0 at vge0 phy 1: Cicada CS8201 10/100/1000TX PHY, rev. 2
pciide0 at pci0 dev 15 function 0 "VIA VT6420 SATA" rev 0x80: DMA
pciide0: using irq 11 for native-PCI interrupt
wd0 at pciide0 channel 0 drive 0: <FUJITSU MHV2060BH>
wd0: 16-sector PIO, LBA48, 57231MB, 117210240 sectors
wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 5
pciide1 at pci0 dev 15 function 1 "VIA VT82C571 IDE" rev 0x06: ATA133,
channel 0
configured to compatibility, channel 1 configured to compatibility
atapiscsi0 at pciide1 channel 0 drive 0
scsibus0 at atapiscsi0: 2 targets, initiator 7
cd0 at scsibus0 targ 0 lun 0: <MATSHITA, DVD-RAM UJ-85JS, FWR7> ATAPI
5/cdrom re
movable
cd0(pciide1:0:0): using PIO mode 4, Ultra-DMA mode 4
pciide1: channel 1 disabled (no drives)
uhci0 at pci0 dev 16 function 0 "VIA VT83C572 USB" rev 0x81: irq 5
uhci1 at pci0 dev 16 function 1 "VIA VT83C572 USB" rev 0x81: irq 5
uhci2 at pci0 dev 16 function 2 "VIA VT83C572 USB" rev 0x81: irq 11
ehci0 at pci0 dev 16 function 4 "VIA VT6202 USB" rev 0x86: irq 10
usb0 at ehci0: USB revision 2.0
uhub0 at usb0 "VIA EHCI root hub" rev 2.00/1.00 addr 1
viapm0 at pci0 dev 17 function 0 "VIA VT8237 ISA" rev 0x00
iic0 at viapm0
spdmem0 at iic0 addr 0x50: 1GB DDR2 SDRAM non-parity PC2-4200CL5
auvia0 at pci0 dev 17 function 5 "VIA VT8233 AC97" rev 0x60: irq 10
ac97: codec id 0x56494182 (VIA Technologies <82>)
ac97: codec features 18 bit DAC, 18 bit ADC, No 3D Stereo
audio0 at auvia0
usb1 at uhci0: USB revision 1.0
uhub1 at usb1 "VIA UHCI root hub" rev 1.00/1.00 addr 1
usb2 at uhci1: USB revision 1.0
uhub2 at usb2 "VIA UHCI root hub" rev 1.00/1.00 addr 1
usb3 at uhci2: USB revision 1.0
uhub3 at usb3 "VIA UHCI root hub" rev 1.00/1.00 addr 1
isa0 at mainbus0
isadma0 at isa0
com0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
com1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
pmsi0 at pckbc0 (aux slot)
pckbc0: using irq 12 for aux slot
wsmouse0 at pmsi0 mux 0
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
spkr0 at pcppi0
wbsio0 at isa0 port 0x4e/2: W83697HF rev 0x12
lm1 at wbsio0 port 0x290/8: W83697HF
npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
biomask efe5 netmask efe5 ttymask ffff
softraid0 at root
root on wd0a swap on wd0b dump on wd0b
TTFN
--
Mike
