Hello again,
I have tried a second card which is an Atheros AR5213A. I can set it
on 11a or 11b but 11g (even though does not make any errors) never
works. It seems to stay stuck at 11b.
I have set it with and without encryption without luck so far.
This is my setup :
inet 192.168.5.1 255.255.255.0 NONE media autoselect mediaopt hostap
mode 11b nwid openbsdap chan 11 wpa wpapsk $(wpa-psk openbsdap
my_secret_key) wpaakms psk
Trying mode 11g just returns to the command line without resetting
anything. Has anyone seen familiar behavior, been googling for a while
without finding a solution so far.
ath0: flags=8863<UP,BROADCAST,NOTRAILERS,RUNNING,SIMPLEX,MULTICAST> mtu 1500
lladdr 00:0b:6b:de:10:f2
priority: 0
groups: wlan
media: IEEE802.11 autoselect mode 11b hostap
status: active
ieee80211: nwid openbsdap chan 11 bssid 00:0b:6b:de:10:f2
wpapsk 0xd.....8b wpaprotos wpa1 wpaakms psk wpaciphers tkip,ccmp
wpagroupcipher tkip
inet6 fe80::20b:6bff:fede:10f2%ath0 prefixlen 64 scopeid 0x4
inet 192.168.5.1 netmask 0xffffff00 broadcast 192.168.5.255
OpenBSD 4.5 (GENERIC) #1749: Sat Feb 28 14:51:18 MST 2009
dera...@i386.openbsd.org:/usr/src/sys/arch/i386/compile/GENERIC
cpu0: Geode(TM) Integrated Processor by National Semi ("Geode by NSC"
586-class) 267 MHz
cpu0: FPU,TSC,MSR,CX8,CMOV,MMX
real mem = 268005376 (255MB)
avail mem = 250855424 (239MB)
mainbus0 at root
bios0 at mainbus0: AT/286+ BIOS, date 20/70/04, BIOS32 rev. 0 @ 0xf7840
pcibios0 at bios0: rev 2.0 @ 0xf0000/0x10000
pcibios0: pcibios_get_intr_routing - function not supported
pcibios0: PCI IRQ Routing information unavailable.
pcibios0: PCI bus #0 is the last bus
bios0: ROM list: 0xc8000/0x9000
cpu0 at mainbus0: (uniprocessor)
cpu0: TSC disabled
pci0 at mainbus0 bus 0: configuration mode 1 (bios)
pchb0 at pci0 dev 0 function 0 "Cyrix GXm PCI" rev 0x00
sis0 at pci0 dev 6 function 0 "NS DP83815 10/100" rev 0x00, DP83816A:
irq 10, address 00:00:24:c8:44:f4
nsphyter0 at sis0 phy 0: DP83815 10/100 PHY, rev. 1
sis1 at pci0 dev 7 function 0 "NS DP83815 10/100" rev 0x00, DP83816A:
irq 10, address 00:00:24:c8:44:f5
nsphyter1 at sis1 phy 0: DP83815 10/100 PHY, rev. 1
sis2 at pci0 dev 8 function 0 "NS DP83815 10/100" rev 0x00, DP83816A:
irq 10, address 00:00:24:c8:44:f6
nsphyter2 at sis2 phy 0: DP83815 10/100 PHY, rev. 1
ath0 at pci0 dev 14 function 0 "Atheros AR5212" rev 0x01: irq 11
ath0: AR5213A 5.9 phy 4.3 rf5112a 3.6, FCC2A*, address 00:0b:6b:de:10:f2
gscpcib0 at pci0 dev 18 function 0 "NS SC1100 ISA" rev 0x00
gpio0 at gscpcib0: 64 pins
"NS SC1100 SMI" rev 0x00 at pci0 dev 18 function 1 not configured
pciide0 at pci0 dev 18 function 2 "NS SCx200 IDE" rev 0x01: DMA,
channel 0 wired to compatibility, channel 1 wired to compatibility
wd0 at pciide0 channel 0 drive 0: <SanDisk SDCFX4-4096>
wd0: 4-sector PIO, LBA, 3919MB, 8027712 sectors
wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 2
geodesc0 at pci0 dev 18 function 5 "NS SC1100 X-Bus" rev 0x00: iid 6
revision 3 wdstatus 0
ohci0 at pci0 dev 19 function 0 "Compaq USB OpenHost" rev 0x08: irq 5,
version 1.0, legacy support
isa0 at gscpcib0
isadma0 at isa0
com0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
com0: console
com1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
spkr0 at pcppi0
nsclpcsio0 at isa0 port 0x2e/2: NSC PC87366 rev 9: GPIO VLM TMS
gpio1 at nsclpcsio0: 29 pins
gscsio0 at isa0 port 0x15c/2: SC1100 SIO rev 1:
npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
usb0 at ohci0: USB revision 1.0
uhub0 at usb0 "Compaq OHCI root hub" rev 1.00/1.00 addr 1
biomask f3e5 netmask ffe5 ttymask ffff
softraid0 at root
root on wd0a swap on wd0b dump on wd0b
