Hi,
according to radeon(4) my graphics card is supported, but I
cannot get hardware acceleration to work. Booting with
"disable radeondrm" in UKC and then running "startx" works
fine. Doing the same with "enable radeondrm" (which is the
default in the GENERIC kernel) appears to freeze the machine.
The screen goes blank, and the monitor enters standby mode.
Sometimes the computer shuts down after pressing the power
button, but most of the time it can only be forced off by
holding the power button.
Trying several options in xorg.conf did not advance things.
I booted with a serial console to see if any messages appeared
after entering "startx". This is what I got:
radeondrm0: Setting GART location based on new memory map
radeondrm0: writeback test failed
radeondrm0: wait idle failed status : 0x80010140 0x00000000
radeondrm0: wait idle failed status : 0x80010140 0x00000000
radeondrm0: wait idle failed status : 0x80010140 0x00000000
...
The last message is repeated over and over until the machine
appears to freeze. The time it takes to get to that point
varies.
After setting 'Option "AGPFastWrite" "on"' in xorg.conf
no messages were output at all, but that was the only
apparent difference.
Setting "AccelMethod" to "EXA" also did not change anything.
Using no xorg.conf at all also did not work.
Anyway, here's my xorg.conf and dmesg. I hope someone
can give me a hint.
Vic
+++ xorg.conf +++
Section "ServerLayout"
Identifier "X.org Configured"
Screen 0 "Screen0" 0 0
InputDevice "Mouse0" "CorePointer"
InputDevice "Keyboard0" "CoreKeyboard"
EndSection
Section "Files"
ModulePath "/usr/X11R6/lib/modules"
FontPath "/usr/X11R6/lib/X11/fonts/misc/"
FontPath "/usr/X11R6/lib/X11/fonts/TTF/"
FontPath "/usr/X11R6/lib/X11/fonts/OTF"
FontPath "/usr/X11R6/lib/X11/fonts/Type1/"
FontPath "/usr/X11R6/lib/X11/fonts/100dpi/"
FontPath "/usr/X11R6/lib/X11/fonts/75dpi/"
EndSection
Section "Module"
Load "dbe"
Load "dri"
Load "extmod"
Load "glx"
Load "freetype"
EndSection
Section "InputDevice"
Identifier "Keyboard0"
Driver "kbd"
EndSection
Section "InputDevice"
Identifier "Mouse0"
Driver "mouse"
Option "Protocol" "wsmouse"
Option "Device" "/dev/wsmouse"
Option "ZAxisMapping" "4 5 6 7"
EndSection
Section "Monitor"
#DisplaySize 340 270 # mm
Identifier "Monitor0"
VendorName "ENC"
ModelName "L557"
HorizSync 24.0 - 80.0
VertRefresh 50.0 - 75.0
Option "DPMS"
EndSection
Section "Device"
Option "AGPMode" "x4"
Option "BusType" "AGP" # [<str>]
#Option "AGPFastWrite" "on" # [<bool>]
#Option "AccelMethod" "EXA" # <str>
Option "DRI" "on" # [<bool>]
Identifier "Card0"
Driver "radeon"
VendorName "ATI"
BoardName "Radeon 9200 PRO"
BusID "PCI:1:0:0"
EndSection
Section "Screen"
Identifier "Screen0"
Device "Card0"
Monitor "Monitor0"
SubSection "Display"
Viewport 0 0
Depth 1
EndSubSection
SubSection "Display"
Viewport 0 0
Depth 4
EndSubSection
SubSection "Display"
Viewport 0 0
Depth 8
EndSubSection
SubSection "Display"
Viewport 0 0
Depth 15
EndSubSection
SubSection "Display"
Viewport 0 0
Depth 16
EndSubSection
SubSection "Display"
Viewport 0 0
Depth 24
EndSubSection
EndSection
+++ dmesg +++
OpenBSD 4.5-stable (GENERIC) #0: Sun May 3 11:29:20 CEST 2009
v...@overstolz.my.domain:/usr/src/sys/arch/i386/compile/GENERIC
cpu0: AMD Athlon(tm) XP 2000+ ("AuthenticAMD" 686-class, 256KB L2 cache) 1.68
GHz
cpu0:
FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE
real mem = 804810752 (767MB)
avail mem = 769404928 (733MB)
mainbus0 at root
bios0 at mainbus0: AT/286+ BIOS, date 10/18/06, BIOS32 rev. 0 @ 0xfdb10, SMBIOS
rev. 2.3 @ 0xf0630 (21 entries)
bios0: vendor American Megatrends Inc. version "P2.80" date 10/18/2006
bios0: American Megatrends Inc. K7S41GX
acpi0 at bios0: rev 0
acpi0: tables DSDT FACP APIC
acpi0: wakeup devices PS2M(S4) PS2K(S4) UAR1(S4) USB1(S4) USB2(S4) EHCI(S4)
LAN_(S4) MDM_(S4) AUD_(S4) PCI0(S4)
acpitimer0 at acpi0: 3579545 Hz, 24 bits
acpimadt0 at acpi0 addr 0xfee00000: PC-AT compat
cpu0 at mainbus0: apid 0 (boot processor)
cpu0: apic clock running at 268MHz
ioapic0 at mainbus0: apid 2 pa 0xfec00000, version 11, 24 pins
acpiprt0 at acpi0: bus 0 (PCI0)
acpicpu0 at acpi0
acpibtn0 at acpi0: PWRB
bios0: ROM list: 0xc0000/0xd000 0xcd000/0xa000
pci0 at mainbus0 bus 0: configuration mode 1 (bios)
pchb0 at pci0 dev 0 function 0 "SiS 741 PCI" rev 0x03
sisagp0 at pchb0
agp0 at sisagp0: aperture at 0xd0000000, size 0x8000000
ppb0 at pci0 dev 1 function 0 "SiS 648FX AGP" rev 0x00
pci1 at ppb0 bus 1
vga1 at pci1 dev 0 function 0 "ATI Radeon 9200 PRO" rev 0x01
wsdisplay0 at vga1 mux 1: console (80x25, vt100 emulation)
wsdisplay0: screen 1-5 added (80x25, vt100 emulation)
radeondrm0 at vga1: apic 2 int 16 (irq 11)
drm0 at radeondrm0
pcib0 at pci0 dev 2 function 0 "SiS 85C503 System" rev 0x25
pciide0 at pci0 dev 2 function 5 "SiS 5513 EIDE" rev 0x00: 741: DMA, channel 0
wired to compatibility, channel 1 wired to compatibility
wd0 at pciide0 channel 0 drive 0: <IBM-DTTA-350840>
wd0: 16-sector PIO, LBA, 8063MB, 16514064 sectors
wd1 at pciide0 channel 0 drive 1: <WDC WD800JB-00ETA0>
wd1: 16-sector PIO, LBA48, 76319MB, 156301488 sectors
wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 2
wd1(pciide0:0:1): using PIO mode 4, Ultra-DMA mode 5
wd2 at pciide0 channel 1 drive 0: <WDC WD1600JB-22GVC0>
wd2: 16-sector PIO, LBA48, 152627MB, 312581808 sectors
atapiscsi0 at pciide0 channel 1 drive 1
scsibus0 at atapiscsi0: 2 targets
cd0 at scsibus0 targ 0 lun 0: <HL-DT-ST, DVD-RAM GSA-H55L, 1.03> ATAPI 5/cdrom
removable
wd2(pciide0:1:0): using PIO mode 4, Ultra-DMA mode 5
cd0(pciide0:1:1): using PIO mode 4, Ultra-DMA mode 4
ohci0 at pci0 dev 3 function 0 "SiS 5597/5598 USB" rev 0x0f: apic 2 int 20 (irq
5), version 1.0, legacy support
ohci1 at pci0 dev 3 function 1 "SiS 5597/5598 USB" rev 0x0f: apic 2 int 21 (irq
3), version 1.0, legacy support
ehci0 at pci0 dev 3 function 2 "SiS 7002 USB" rev 0x00: apic 2 int 23 (irq 10)
usb0 at ehci0: USB revision 2.0
uhub0 at usb0 "SiS EHCI root hub" rev 2.00/1.00 addr 1
sis0 at pci0 dev 4 function 0 "SiS 900 10/100BaseTX" rev 0x90: apic 2 int 19
(irq 5), address 00:19:66:65:10:93
rlphy0 at sis0 phy 1: RTL8201L 10/100 PHY, rev. 1
trm0 at pci0 dev 9 function 0 "Tekram DC-3x5U" rev 0x01: apic 2 int 17 (irq 5)
scsibus1 at trm0: 8 targets, initiator 7
envy0 at pci0 dev 10 function 0 "IC Ensemble Envy24 I/O Ctrlr" rev 0x02: apic 2
int 18 (irq 10)
audio0 at envy0
isa0 at pcib0
isadma0 at isa0
com0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
pms0 at pckbc0 (aux slot)
pckbc0: using irq 12 for aux slot
wsmouse0 at pms0 mux 0
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
spkr0 at pcppi0
lpt0 at isa0 port 0x378/4 irq 7
wbsio0 at isa0 port 0x2e/2: W83697HF rev 0x12
lm1 at wbsio0 port 0x290/8: W83697HF
npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
fdc0 at isa0 port 0x3f0/6 irq 6 drq 2
fd0 at fdc0 drive 0: 1.44MB 80 cyl, 2 head, 18 sec
usb1 at ohci0: USB revision 1.0
uhub1 at usb1 "SiS OHCI root hub" rev 1.00/1.00 addr 1
usb2 at ohci1: USB revision 1.0
uhub2 at usb2 "SiS OHCI root hub" rev 1.00/1.00 addr 1
mtrr: Pentium Pro MTRR support
softraid0 at root
root on wd1a swap on wd1b dump on wd1b
radeondrm0: Setting GART location based on new memory map
radeondrm0: writeback test failed
radeondrm0: wait idle failed status : 0x80010140 0x00000000
radeondrm0: wait idle failed status : 0x80010140 0x00000000
radeondrm0: wait idle failed status : 0x80010140 0x00000000
...
--
Nur bis 31.05.: GMX FreeDSL Komplettanschluss mit DSL 6.000 Flatrate und
Telefonanschluss nur 17,95 Euro/mtl.!* http://portal.gmx.net/de/go/dsl02
