New problem. I can't get the 17mm bolt on the tranny mount isn't comming off. I can turn it, but it won't come off. It will loosen, then tighten, then loosen etc. Tipical indications of screwed up threads. What should I do? I have a complete donor car to work with if I mess up some parts. I unbolted the entire tranny mount. Now I am trying to remove the bracket that holds the tranny to the mount. I'm talking about two parts. The part that bolts to the tranny over above the green end cap. I'm also trying to remove the bracked that bolts to the bell housing, by the orange shifter bushing. I can't get this part off though. I'll probably have to drill the 17mm bolt off tomarrow. Any suggestions? Here is where I am at so far. Motor mounts disconnected starter removed Drive shafts disconnected All shift linkages are disconnected Battery is removed Intake tube is removed I removed the three bolts holding the control arm to the spindle on both sides. I realize now that I only needed to do the drivers side. Oh well.
________________________________________________________________ GET INTERNET ACCESS FROM JUNO! Juno offers FREE or PREMIUM Internet access for less! Join Juno today! For your FREE software, visit: http://dl.www.juno.com/get/tagj. _____________ List Sponsor: http://www.netsville.com To remove yourself from this list, send mail to [email protected] with 'unsubscribe a2_16v' in the body of your message See us on the web at http://www.a2-16v.com Visit the 16V Homepage at http://www.gti16v.org
