2009/7/8 Mark Burton <ma...@ordern.com>: > > Marco, > >> I still do not see the reason to make 2 unaccessible arcs on both sides >> instead of one. > > Imagine that you have only one restricted arc that is on one side of > the bollard. Now if you are within that region and try to route to a > point that is on the other side of the bollard, it will route straight > through the bollard because you are leaving the restricted area and not > entering it. If you have two restricted areas, one each side of the > bollard and your starting point is within one of the areas, it will now > not route through the bollard if the destination is outside of the > restricted area on the other side of the bollard. > > As previously mentioned, the case where both start and destination are > within the restricted area does not work right and, currently, I don't > have a plan for fixing this. I can't see how that can be achieved.
Hi Mark! Is there any chance for this patch to get committed in the near future? I think it would be very helpful for routing (also with barrier=cycle_barrier/gate/lift_gate etc) and the case of target and/or destination being too close to the barrier is not that common. Thank you for any info! -Martin _______________________________________________ mkgmap-dev mailing list mkgmap-dev@lists.mkgmap.org.uk http://www.mkgmap.org.uk/mailman/listinfo/mkgmap-dev