Bob, Last summer I purchased corks for my cockpit drains from a camping
supply store close my launch site prior to a 3-man camp-cruise (the weight
of the three of us plus gear caused the boat to ship water under all
weight-distribution scenarios):  The corks worked great . . . But I can't
help wondering . . . Isn't this somewhat dangerous, given that one could be
caught in a Charless Fowlkes (a-la the discussion on M15 buoyancy) scenario?
I mean, the drains are designed to dump a cockpit full of water in the event
the boat were swamped . . . I guess, theoretically, or hopefully, one would
have the time to pull the corks in a crisis.  --Craig

----- Original Message -----
From: "Bob Campbell" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Thursday, April 25, 2002 11:37 AM
Subject: cockpit drain backwash


Cal,

I have had similar wet cockpit problems with my M17.  I was getting
water in from both the center board pennant, and the transom drains.  My
solution is rubber stoppers in the drains, and rubber rigging tape (the
kind that only sticks to itself) wrapped around the centerboard pennant
in a tapered fashion, and stuffed into the pennant hole.  This keeps the
cockpit dry as a bone, and when conditions start getting nasty, I pull
out the transom drain stoppers.  I figure, if there's water coming in
over the combings, it doesn't much matter if there's water splashing in
though the cockpit drains.  All this is to say; maybe you could devise a
way to plug the drain when you don't need the drainage.

Cautionary note:  If you keep your boat in the water or dry store it
outside, don't forget to pull the plug(s) so that rain water can drain
out!  I read a story of a Potter 15 owner who came back to his "stopped
up" boat after a rain storm to find his cabin flooded and boat half
sunk! By the grace of God, I haven't pulled this stunt yet :)

Fair Winds,

Bob Campbell
Montgomery 17 #615 "Alina"
Lodi, CA

-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]] On Behalf Of Cal
Spooner
Sent: Thursday, April 25, 2002 3:32 AM
To: [EMAIL PROTECTED]
Subject: Re: M_Boats: cockpit drain backwash

Steve,
There is really no solution other than to get one of those mats that
bartenders use (and boat shops sell) that are about 1" thick and made
of alternating squares (checkerboard pattern) of rubber, trim it and
throw it on the floor of the cockpit. The design of the drain makes
water come up sometimes when tacking into the wind, and other
conditions, in rough water... the waves force the water up; your
"hydraulic pressure" analogy is correct. There is no simple solution
to this... but the mat will keep your feet dry, and allow the water
to drain back out.

At 9:01 PM -0500 4/24/02, Steve McClellan \(at Home\) wrote:
>It just so happens that I have been turning this issue (cockpit drain
>backwash) over and over in my head for the past couple of days.
>
>The reason is, I recently removed the teak pennant guide and have
ground
>away a good deal of the fiberglass around the drain hole, as a small
part of
>a larger project that began a few weeks ago with a centerboard that
wouldn't
>drop, and is going to end with a complete refurbishment of my keel
stub,
>centerboard trunk, centerboard, and cockpit drain.
>
>And the big question that has been getting me lately is: Why isn't
there
>SOME permanent solution to the drain backwash problem on the M15s?
There
>must be an answer.  What is it?
>
>With the teak piece gone, the drain opening is actually quite large,
about 1
>inch by 2 inches I'd say.  BUT consider: it is at the top of an
inverted
>triangular slot, the centerboard slot, which means that as water
pressure
>causes water to move up the slot, it is progresively accelerated by the
>ever-narrowing passage, until it is forced with some considerably
multiplied
>hydraulic pressure up the through the drain hole.
>
>It seems like, with the centerboard removed, one should be able to
install
>some kind of a "valve" or flap that would allow water to move downward
with
>ease (necessary) but not UPward at all.  Whatever kind of spring
loading
>kept the valve flap up, it would have to be something weak enough that
even
>small amounts of water from above would overcome it.
>
>The other possibility might be some kind of a float that would jam
itself up
>into the hole from below when water was moving upward.
>
>Come on people, put on your thinking caps!  I'm willing to be the
guinea pig
>for whatever good idea we can come up with.  (I've got the think all
taken
>apart and up on stands anyway)  It needs to be something both simple
and
>reliable.
>
>----- Original Message -----
>From: "Mark Pavuk" <[EMAIL PROTECTED]>
>To: <[EMAIL PROTECTED]>
>Sent: Wednesday, April 24, 2002 6:42
>Subject: M_Boats: cockpit drain
>
>>  Is it normal to have water entering the cockpit from the drain? We
>>  sailed today and had a wonderful time - the only problem was a bit
of
>>  water getting splashed up and getting our feet and the main sheet
wet. I
>>  assumed self-bailing was a one way street somehow. Are we missing
>>  something?
>  Cherri, M-15 # 322
--
Cal Spooner
M15 #402
[EMAIL PROTECTED]
[EMAIL PROTECTED]
763.574.1482

_______________________________________________
http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats


_______________________________________________
http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats


_______________________________________________
http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats

Reply via email to