Jerry M. has posted that the older M-15s were built to use a certain pottie. Then the pottie makers changed the shape slightly, which meant the pottie no longer fit. He suggested heating the base of the pottie with a hair dryer then fitting it in place. I did not have much luck with the hair dryer, and used waster at about 140 degrees F. It took maybe half a gallon. I pushed the pottie as far as it would go then poured in the warm water. Assume the proper position sir and you will have a custom fitted pottie!
If I were doing it over I would line the recess with something like masking tape to give a little clearance to remove and reinstall the pottie. Maybe even place some half round molding on the bottom to lessen the "wrinkling". I was a little concerned about this but the pottie does not leak. I have the smallest Thetford model, I think it is the 135. Steve R. M-15 #119 Lexington, KY --- "Ken Abrahams" <[EMAIL PROTECTED]> wrote: >Alvin's new M15 has a small Port a Pottie in it. I had Alvin order me one >like his. To our surprise, the indention in the floor in my boat is >narrower than his and the potty will not fit. My indentation is 11 by 15 >in. The Pottie is 12 in. wide. >Anyone else have this problem? How solved? > >Ken Abrahams, M15, Petite Fleur, Lake Charles, La. > > >_______________________________________________ >http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats _______________________________________________ http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats
