In a message dated 8/24/2007 5:19:23 PM Mountain Standard Time, [EMAIL PROTECTED] writes:
Well, i put some Seafoam in the gas tank and couldn't get the engine to turn over. I inspected the plug and (mind you i am no mechanic) it looked a bit oily for such a new engine... i have probably less than 10 hours on it in a years time... the plug was not crusty or anything, just dark... i emory clothed it clean at the tip and reinstalled it. It seems to me that if i could get it to turn over just a bit it would limp along until the Seafoam started working. What would happen if i put some gas in the spark plug "hole" (told ya i was no mechanic)? Any suggestions? _______________________________________________ http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats Rather than gas in the plug hole, spray WD40 in the carb intake. Then crank it over. Lots of times, spark plugs will look good on a 2 stroke, but they need changing. They tend to run hot. What engine do you have and how long has it sat? Sandy ************************************** Get a sneak peek of the all-new AOL at http://discover.aol.com/memed/aolcom30tour _______________________________________________ http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats
