Jim: I made a Bimini that doubled as a mast support for trailering. Sort of acted like a stern pulpit. I used pipe flanges mounted on the transom for 2 vertical supports there & a U- shaped piece supported by them. The ends of the U were attached to the toe rail a foot or 2 ahead of the transom. G.
Sent from my iPhone On Mar 16, 2008, at 5:29 AM, jim sadler <[EMAIL PROTECTED]> wrote: > Thanks Gary > Do you know what the "different design" is or who makes one of the > different design? > Bob just finished installing a bow pulpit on the Pelican. It is > beautiful! > > Capt'n Jim > > On Sun, Mar 16, 2008 at 12:04 AM, Gary M Hyde <[EMAIL PROTECTED]> wrote: > >> Bob Egg installs them at the factory before putting deck on hull but >> it's tough to add it later. U need a different design since U can't >> get under the deck to install bolts. >> Gary. >> >> Sent from my iPhone >> >> On Mar 15, 2008, at 8:48 PM, jim sadler <[EMAIL PROTECTED]> >> wrote: >> >>> Skippers >>> >>> Have any of you installed a stern pulpit? How difficult is it? It >>> sure >>> seems like a nice addition. >>> >>> Capt'n James Sadler >>> skipper sailing vessel Pelican M-15 >>> _______________________________________________ >>> http://mailman.xmission.com/cgi-bin/mailman/listinfo/ >>> montgomery_boats >> >> _______________________________________________ >> http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats >> > _______________________________________________ > http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats _______________________________________________ http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats
