-------- Original Message --------
Subject: Re: error when doing RelW
Date: Wed, 19 Jan 2011 15:08:12 -0500
From: Shahin Muttalib <[email protected]>
To: [email protected]
Hello,
Thank you Andrea and Viviana, I was able to convert the TPS file to NTS,
although the analysis still doesn't work for the TPS format. Does
TPSRELW perform the same analysis on both file formats ?
Additionally, on one batch of photos, in addition to 16 landmarks, two
vertical lines were drawn on the image. TPSRELW doesn't seem to want to
analyze this batch (It gives the error: invalid floating point operation).
Do you know of any way around this, or will I have to go and remove
these "curves" and "points" individually ?
cheers,
Shahin
2011/1/19 andrea cardini <[email protected]
<mailto:[email protected]>>
Dear Shanin,
I suggest you to check if the file loads fine in other programs
(TPSDig,
TPSSmall, MorphoJ etc.) and if you can convert it into NTS using
TPSUtil.
If not, Viviana is probably right: there's an error somewhere.
I cannot promise to find time but if you want to send me the file and
you're not in a rush, I may have a chance to give a look and see if
I can
find something odd.
Cheers
Andrea
At 14:38 18/01/2011 -0500, you wrote:
>
>
>-------- Original Message --------
>Subject: Re: error [tpsrelw -the mod]
>Date: Tue, 18 Jan 2011 12:36:56 -0500
>From: M. Viviana Toro Ibacache <[email protected]
<mailto:[email protected]>>
>To: [email protected] <mailto:[email protected]>
>
>Dear Shanin,
>
>On my experience, when TPS Relative Warps shows that kind of message
>there is usually a problem with the landmark file. Sometimes (I don´t
>know why), the is a comma where a point should be, or something like
>that. I suggest you examine the data file and compare it with another
>one that runs correctly, and check.
>
>Hope this helps,
>
>Viviana
>
>2011/1/18, morphmet <[email protected]
<mailto:[email protected]>>:
>>
>>
>> -------- Original Message --------
>> Subject: error
>> Date: Mon, 17 Jan 2011 12:54:10 -0500
>> From: Shahin Muttalib <[email protected]
<mailto:[email protected]>>
>> To: [email protected] <mailto:[email protected]>
>>
>>
>>
>> Hi
>>
>> I just started trying to use the TPSRELW software. When I try
to upload
>> my data, it says "unrecognized parameter: scale".
>>
>> Does this mean TPSRELW can't use the scale data ?
>>
>> Additionally, after this error, I have to use ctrl-alt-del to
shut down
>> the program.
>>
>> Help would be appreciated :)
>>
>>
>> *[email protected] <mailto:[email protected]>
<mailto:[email protected] <mailto:[email protected]>>*
>> --
>> Shahin Muttalib
>> 438-883-4300 (cell)
>>
>>
>
>
>--
>M. Viviana Toro Ibacache CD, MgCs
> Académico
> Universidad de Chile
>
>
>
>
--
Shahin Muttalib
438-883-4300 (cell)
