----- Forwarded message from Brian Corner <[email protected]>
-----
Date: Thu, 31 Jan 2013 08:38:16 -0500
From: Brian
Corner <[email protected]>
Reply-To: Brian Corner
<[email protected]>
Subject: RE: ? Programs
To:
[email protected]
Bill's comments
are terrific, I'm going to try Seg3D myself. He's spot-on about MeshLab, quirky
but when it works it works well and gives you plenty of control over your
mesh.
You may also want to check 3dSlicer (http://www.slicer.org/), another open-source CT/MRI program, and
TINA was mentioned in this forum not too long ago.
One thing to remember about using CTs, processing takes lots of horsepower. Make
sure you have a graphics card that will handle the rendering and CPU for number
crunching.
Look forward to reading about your success.
-bc
Brian Corner
Research Anthropologist
NSRDEC
USA
----- End forwarded message -----
