----- Forwarded message from Carmelo Fruciano <[email protected]> -----
Date: Tue, 10 Jun 2014 04:01:02 -0400
From: Carmelo Fruciano <[email protected]>
Reply-To: Carmelo Fruciano <[email protected]>
Subject: Re: landmark configuration reflection
To: [email protected]
[email protected] ha scritto:
>
> ----- Forwarded message from Miguel Eduardo Delgado Burbano -----
>
> Date: Thu, 5 Jun 2014 17:59:15 -0300
> From: Miguel Eduardo Delgado Burbano
> Reply-To: Miguel Eduardo Delgado Burbano
> Subject: landmark configuration reflection
> To: [email protected]
>
> Hi all
>
> I am performing a 2D geometric morphometric study using human
> skulls. In a previous research I digitized several landmarks and
> semilandmarks in the right half of the face, but now I am trying to
> perform an analysis using the complete face (i.e both halfs), so in
> order to not digitized again perhaps I can reflect the right
> landmark configuration on the left side. Since the reflection is
> performed during the procrustes (GPA) perhaps a particular software
> allows to reflect the landmark configuration TPS, MorphoJ, GeoMorph
> etc??
>
> any suggestions?
Hi Miguel,
Normally these days when I have to do these reflections I use Matlab.
For an older paper (Fruciano et al. 2011 - It J Zool) I think I used
LMedit from the IMP package (it's been a while now).
However, if your data is only on half of the face, I would perform the
analysis only on half the face and then use reflection across a
symmetry axis only to display the results...
Best,
Carmelo
--
Carmelo Fruciano
Marie Curie Fellow - University of Konstanz - Konstanz, Germany
Honorary Fellow - University of Catania - Catania, Italy
e-mail [email protected]
http://www.fruciano.it/research/
----- End forwarded message -----
