Hi Wyatt,
thanks your input, we could solve our problem as well. The DCE is one of the two causes.
we have a Solaris box with MQ5.2 CSD04 and Websphere. After reinstall without DCE, before slip throught our control, the base worked. But after install csd04, it failed with different error: "unable to load module amqzfu". However, we have another Solaris box with MQ5.2, csd04, MQSI, and workflow, everything works fine.
Do you happen to know if there is any cross interference between websphere and MQ, specifically csd04?
best regards,
Benjamin Zhou
State Street Corp.
-----Original Message-----
From: Wyatt, T. Rob [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, May 28, 2003 12:26 PM
To: [EMAIL PROTECTED]
Subject: Re: MQSeries installation problem
Ganesh,
Two things I would check here...
First, when the install is performed a common mistake is to select all
options, including the DCE support, even though the server is not in a DCE
environment.
The second thing is the kernel parms. IBM published new values that
superceded the Quick beginnings book at one point. I don't know whether the
Quick Beginnings book has been updated so I am including the values as they
were published on this mailing list a while back.
set msgsys:msginfo_msgmap=1026
set msgsys:msginfo_msgmax=4096
set msgsys:msginfo_msgmnb=4096
set msgsys:msginfo_msgmni=50
set msgsys:msginfo_msgseg=2048
set msgsys:msginfo_msgsz=8
set msgsys:msginfo_msgtql=1024
set semsys:seminfo_semaem=16384
set semsys:seminfo_semmap=1026
set semsys:seminfo_semmni=1024
set semsys:seminfo_semmns=32767
set semsys:seminfo_semmnu=2048
set semsys:seminfo_semmsl=128
set semsys:seminfo_semopm=128
set semsys:seminfo_semume=256
set semsys:seminfo_semvmx=32767
set shmsys:shminfo_shmmax=4194304
set shmsys:shminfo_shmmni=1024
set shmsys:shminfo_shmseg=1024
We also found this to be helpful:
set rlim_fd_cur=1024
Regards,
-- T.Rob
-----Original Message-----
From: Ganesh V [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, May 28, 2003 1:25 AM
To: [EMAIL PROTECTED]
Subject: MQSeries installation problem
Can someone help on this..
We are facing problems with MQSeries after installing WebSphere MQ
Server 5.2 on Sun Solaris 5.8 box.
Whenever we create a QM, the QM is created but it gives an error
'Segmentation fault'.
The status of the QM is 'Ended Normally' as shown below.
$ dspmq
QMNAME(QM1) STATUS(Ended normally)
When we try to start the QM, the following error is thrown.
$ strmqm
AMQ7002: An error occurred manipulating a file.
Thanks,
Ganesh.
Instructions for managing your mailing list subscription are provided in
the Listserv General Users Guide available at http://www.lsoft.com
Archive: http://vm.akh-wien.ac.at/MQSeries.archive
Instructions for managing your mailing list subscription are provided in
the Listserv General Users Guide available at http://www.lsoft.com
Archive: http://vm.akh-wien.ac.at/MQSeries.archive
