I have been running MRTG for about 2 years now. I have my config file kicking off a lot of custom scripts to check disk space, mem free, etc. I was running version 2.9.17. I am building a new box and installed 2.10.13. I brought my mrtg.cfg over from my old box to the new. Now when I run MRTG I get boatloads of "WARNING: Problem with External get '/usr/local/nagios/libexec/./check_nt_mrtg -H 10.0.x.x -p 1248 -v CPULOAD -l 1,100,100': Expected a Number for 'out' but nothing'" messages. My scripts typically return a single number representing a value (ie: 800 to represent 800 gigs free). After looking through the docs, changelog, and reading the output of the error message it looks like MRTG now *requires* four lines of output? If so I will have to rewrite all my scripts to deal with this, which isn't a huge deal... but I was wondering if there was any way to get the "old" behavior back? Thanks, Mark Capelle CONFIDENTIALITY NOTICE: This e-mail may contain trade secrets or privileged, undisclosed or otherwise confidential information. If you have received this e-mail in error, you are hereby notified that any review, copying or distribution of this message in whole or in part is strictly prohibited. Please inform the sender immediately and destroy the original transmittal. Thank you for your cooperation. -- Unsubscribe mailto:[EMAIL PROTECTED] Archive http://www.ee.ethz.ch/~slist/mrtg FAQ http://faq.mrtg.org Homepage http://www.mrtg.org WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi