Hi, Thank you for your kind responce. I did configure with: ..... MaxBytes[target_1]: 16000 AbsMax[target_2]: 1250000 Unscaled[target_1]: d .....
This also results in spike to 6Mbps of data. It did not achieve what I want. I need something like the graph display should remain on say 200kbps even if traffic crosses above 200kbps. It should not record 0 value during that particular time. Once again thanks for your kind responce. Best regds, Rajendra [EMAIL PROTECTED] wrote: >It sounds to me like setting MaxBytes to 16000, AbsMax to a higher value >(i.e. the highest value you wish to record) and changing the graphs to >UnScaled would achieve what you want. > >Regards, > >Scott. > >-----Original Message----- >From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] >On Behalf Of Rajendra Adhikari >Sent: 04 April 2006 11:36 >To: [EMAIL PROTECTED] >Subject: [mrtg] Re: Chop MRTG graph > >Hi, >I have one prfoblem about recording the values by mrtg. >I have set MaxBytes: 8000 >and, AbsMax: 16000 >I understand that whenever the traffic is above the 16000 then mrtg >records the zero value unless the traffic is below AbsMax. >I need something that the value does not get recorded to zero but chop >off at AbsMax so that I could see the constant AbsMax value in the graph > >whenever the value is equal or above AbsMax. .i.e. the vlaue shall be >chopped at the AbsMax. > >I will appreciate your suggestions. > >Best Regds, >Rajendra Adhikari > > >-- >Unsubscribe mailto:[EMAIL PROTECTED] >Archive http://lists.ee.ethz.ch/mrtg >FAQ http://faq.mrtg.org Homepage http://www.mrtg.org >WebAdmin http://lists.ee.ethz.ch/lsg2.cgi > >-- >Unsubscribe mailto:[EMAIL PROTECTED] >Archive http://lists.ee.ethz.ch/mrtg >FAQ http://faq.mrtg.org Homepage http://www.mrtg.org >WebAdmin http://lists.ee.ethz.ch/lsg2.cgi > > > > > > -- Unsubscribe mailto:[EMAIL PROTECTED] Archive http://lists.ee.ethz.ch/mrtg FAQ http://faq.mrtg.org Homepage http://www.mrtg.org WebAdmin http://lists.ee.ethz.ch/lsg2.cgi
