How do you create the graph with the sum?
When using a cfg file with Target: [EMAIL PROTECTED] + [EMAIL PROTECTED] + ...
you will almost certain run into problems with counter rollovers.
Without rrd for backend it isn't possible to create summarized graphs of
(bandwith-)rates that are 100% accurate.
HTH,
Jan.
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of NAP
Sent: Wednesday, September 05, 2007 7:52 PM
To: [email protected]
Subject: [mrtg] Error in sum interfaces
We have problem with interface sums. The values in the independent
graphics don't correspond to the total value that we graphic.
The file .cfg of independent interfaces and the sum graphic is the same.
What will be the problem?
We need help
Thanks,
E T E C S A
UNIDAD NEGOCIOS DATOS
Gestión NAP
e-mail: [EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]>
Tel: 882-8104 / 885-4242
_________________________________________________________
Dit bericht kan informatie bevatten die niet voor u is bestemd. Indien u niet
de geadresseerde bent of dit bericht abusievelijk aan u is toegezonden, wordt u
verzocht dat aan de afzender te melden en het bericht te verwijderen. De staat
aanvaardt geen aansprakelijkheid voor schade, van welke aard ook, die verband
houdt met risico's verbonden aan het elektronisch verzenden van berichten.
_________________________________________________________
This message may contain information that is not intended for you. If you are
not the addressee or if this message was sent to you by mistake, you are
requested to inform the sender and delete the message. The state accepts no
liability for damage of any kind resulting from the risks inherent in the
electronic transmission of messages.
________________________________________________________________________________________________________
mrtg mailing list
[email protected]
https://lists.oetiker.ch/cgi-bin/listinfo/mrtg
