Sounds as if what you need is the interface filter rather than a template. Depending on how you want to limit the selected interfaces, this may do it - if you want to do only ethernet interfaces and not WAN, for example, then filters are perfect for the job. If you want to specify 'just Gi1_3 and Gi3_6' then this is harder.
You could do it with an interface template - with a bit of coding. I might write one to do this. You can append interface templates (and host templates) to combine mul;tiple requirements. Steve ________________________________________ From: [EMAIL PROTECTED] [EMAIL PROTECTED] On Behalf Of Mersberger, Robert [EMAIL PROTECTED] I have been looking at the templates you have loaded and hope to try some of them next week. I would like the ability to run cfgmaker for only selected interfaces and was wondering if I would need a template to do this? This would be on Cisco equipment mainly. _______________________________________________ mrtg mailing list [email protected] https://lists.oetiker.ch/cgi-bin/listinfo/mrtg
