hi lyming i think your board is NOT the problem ...
to establish a connection between your MSP430 and the JTAG interface you only need to connect these lines: Vcc, GND, TDO, TDI, TCK, RESET, and in some cases TEST (e.g. MSP430F1121) you even do not need a crystal! try to run this minimal configuration... good luck, matthias -----Ursprüngliche Nachricht----- Von: [email protected] [mailto:[email protected]] Gesendet: Freitag, 28. März 2003 19:07 An: [email protected] Cc: [email protected] Betreff: Re: [Mspgcc-users] fpga/clpd off-topic Hello Dmitry, I design a msp430 board, but it's not work. I probe the pin of 32.768k crystal, one pin the amplitude just 600mV, another pin the amplitude is almost zero. And I can't connect it to FET. Is there anything wrong? -- Best regards, lyming mailto:[email protected] ------------------------------------------------------- This SF.net email is sponsored by: The Definitive IT and Networking Event. Be There! NetWorld+Interop Las Vegas 2003 -- Register today! http://ads.sourceforge.net/cgi-bin/redirect.pl?keyn0001en _______________________________________________ Mspgcc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/mspgcc-users
