Hi
I probably have a very common problem here, so I hope someone can help
here:
When starting the debugger and trying to step through it hangs:
GDB proxy generates the following:
I also don't seem to get it to burn the MCU correctly?
debug: msp430-gdbproxy.exe: timeout while reading from GDB
debug: msp430-gdbproxy.exe: sending packet: 8 bytes: $ffff#98...
debug: msp430-gdbproxy.exe: ACK received
debug: msp430-gdbproxy.exe: got ACK
debug: msp430-gdbproxy.exe: packet received: Hc0
debug: msp430: msp430_set_ctrl_thread()
debug: msp430-gdbproxy.exe: timeout while reading from GDB
debug: msp430-gdbproxy.exe: sending packet: 4 bytes: $#00...
debug: msp430-gdbproxy.exe: ACK received
debug: msp430-gdbproxy.exe: got ACK
debug: msp430-gdbproxy.exe: packet received: E06,ffe0,10000
debug: msp430-gdbproxy.exe: timeout while reading from GDB
debug: msp430-gdbproxy.exe: sending packet: 4 bytes: $#00...
debug: msp430-gdbproxy.exe: ACK received
debug: msp430-gdbproxy.exe: got ACK
debug: msp430-gdbproxy.exe: packet received: S06
debug: msp430: msp430_resume_from_current(step, 6)
debug: MSP430_Run()
error: msp430: Could not single step device (16)
debug: msp430-gdbproxy.exe: timeout while reading from GDB
debug: msp430-gdbproxy.exe: sending packet: 7 bytes: $E00#a5...
debug: msp430-gdbproxy.exe: ACK received
debug: msp430-gdbproxy.exe: got ACK
debug: msp430-gdbproxy.exe: Control-C received
Riaan Doorduin
Power Electronics Group
Dept. Electrical and Electronic Engineering
University of Stellenbosch
Tel. +27 84 816 3790
+27 21 808 3220 (ext 2)
Fax. +27 21 808 3554
mailto:[email protected]
