Hello, we tried to use an external resistor for Rosc and set the DCOR bit as it is described in the Users Guide to get the same behavour as the old 1xx-devices, but it didn't work:-( So, what program do you use for programming the flash? msp430-gdbproxy?
Regards, Robert Gunther Lemm wrote: > Robert Diemer wrote: > > BUT, I can't program the device with msp430-jtag... There are errors in > > writing the funclets correct into the RAM, but the verify process is > > in most cases not successfull:-( > > If it is once successfull, then the correct flash-programming frequency of > > the DCO can't > > be found. > > I don't think I've ever used msp430-jtag. As you're talking about DCO > frequencies, does msp430-jtag support 16MHz devices? They use 4 bits for > their DCO settings (instead of 3 bits in the old 8MHz devices). Maybe > that's one of the reasons for you programming problems. > > Gunther > > ------------------------------------------------------------------------- > This SF.net email is sponsored by: Microsoft > Defy all challenges. Microsoft(R) Visual Studio 2008. > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ > _______________________________________________ > Mspgcc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/mspgcc-users > -- ------------------------------------------------------------------------ Dipl.-Ing. Robert Diemer http://www.rcs.ei.tum.de Institute for Real-Time Computer Systems (RCS) fon +49-89-289-23731 Technische Universitaet Muenchen, D-80290 Muenchen fax +49-89-289-23555
