Dear all, Sebastian,
I have a problem in below case, please review and correct, if anything
missing ?
mcproxy downstream interface is not able to function on tunnel interface
like pppoe mode
Details:
1.configure MCProxy with upstream as eth1 and downstream as wan-ppp0
(Where wan-ppp0 is PPPoE Client interface running on top of eth0)
2.start Multicast UDP stream from H2.
3.Start a multicast listener @H1 over the PPPoE-server end point
connected interface.
4) Though i am able to see the IGMP Join, messages receiving at wan-ppp0
interface of mcproxy IFCONFIG Rx packats, the multicast stream is not
reaching to H1. ( the route also updated in ip_mr_cache )
5) Wheras, in place of PPPoE tunnel between H1 and Router, if plain
interface is used, then the Mcast route is forming successfully in Router
and able to receive stream at H1.
Queries:
q1) Is there anything extra configuration to be done for this kind of
tunnel interfaces ?
q2) Were there any latest patches to address this issue.
H1 =================================== Mcproxy/Router
====================== H2
(downstream)wan-ppp0/eth0
eth1(upstream)
pppoe-server pppoe-client mode
Stream Listener
Stream-Sender
*my mcproxy.conf looks as below:*
*protocol IGMPv3;*
*pinstace myProxy: eth1 ==> wan-ppp0;*
--
You received this message because you are subscribed to the Google Groups
"Multicast Proxy" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/d/optout.
