Probably for Taylor: Snippet of console output from setup program scanning for channels (in a part of the channels where there is some actual QAM):
2005-02-19 10:22:39.152 DVB#0 Signal Locked 2005-02-19 10:22:39.311 DVB#0 DVB signal fa20 | snr d976 | ber 6c58 | unc f 2005-02-19 10:22:39.311 DVB#0 Status: LOCK. Setting currenTID = 47 2005-02-19 10:22:44.422 DVB#0 DVB signal fff0 | snr 0 | ber 0 | unc 0 2005-02-19 10:22:44.477 DVB#0 Signal Lost 2005-02-19 10:22:44.725 DVB#0 Status: LOCK. Setting currenTID = 48 2005-02-19 10:22:44.731 DVB#0 Signal Locked 2005-02-19 10:22:49.836 DVB#0 Signal Lost 2005-02-19 10:22:50.090 DVB#0 Signal Locked 2005-02-19 10:22:50.348 DVB#0 DVB signal fb30 | snr dc08 | ber 228 | unc e 2005-02-19 10:22:50.348 DVB#0 Status: LOCK. Setting currenTID = 49 2005-02-19 10:22:55.459 DVB#0 DVB signal 0 | snr 0 | ber 0 | unc 0 2005-02-19 10:22:55.460 DVB#0 Signal Lost 2005-02-19 10:22:55.714 DVB#0 Signal Locked 2005-02-19 10:22:55.762 DVB#0 Status: LOCK. Setting currenTID = 50 2005-02-19 10:23:00.874 DVB#0 Signal Lost 2005-02-19 10:23:01.383 DVB#0 Signal Locked 2005-02-19 10:23:01.383 DVB#0 DVB signal fb40 | snr dcc4 | ber 108 | unc 10 2005-02-19 10:23:01.384 DVB#0 Status: LOCK. Setting currenTID = 51 The dtv_multiplex table gets populated, but after the scan there are simply no channels listed. As I mentioned on IRC, I have a standalone samsung HDTV box, so I know that QAM is working on the cable. You probably need more output than that, but it's not immediately obvious to me what I need to do to SIPARSER() and SISCAN() defines in the .h's to make them produce more output. - thor
_______________________________________________ mythtv-dev mailing list mythtv-dev@mythtv.org http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-dev
