Hi, I tried what you said, it didn't work. So I thought I should try with the highest number "1" and then go down as needed. That didn't work either. The blue line remains there. I even tried to reboot after the changes, thinking that maybe that's where the problem is. It's like nothing works!!!
Also, this is only when watching TV or recordings. If I go to weather or system info or the main menu, the blue line isn't there...(if this helps anyone) Thanks, --a-- On Sat, 05 Mar 2005 16:10:56 -0500, Calvin Harrigan <[EMAIL PROTECTED]> wrote: > Ashu Desai wrote: > > >Hi, > >I did the overscan option. I went for TVOverScan upto 5.5, but nothing > >happened!!! > > > >Thanks in advance for your help. > > > >--a-- > > > > > >On Fri, 04 Mar 2005 11:29:30 -0500, Calvin Harrigan > ><[EMAIL PROTECTED]> wrote: > > > > > >>Ashu Desai wrote: > >> > >> > >> > >>>Hello guys, > >>>A newbie here. I wrote a couple of weeks back, and although a few guys > >>>tried to help me, it didnt work. My appeal again: > >>> > >>>I am running pvr-250 (980) on a P3-650 Mhz-640 Mb RAM computer. When I > >>>watch TV or the recording (since it's going to record the way it comes > >>>on TV), I get a blue line on the left side the the upper side. Someone > >>>suggested xattr thing with an "&" at the end; but that didn't work. > >>>Someone also suggested modifying the /usr/bin/nVidia-Settings-1.0-6629 > >>>file but that didn't work either. I am at at brickwall now. Nothing > >>>works and I hate watching my myth tv now with that bar.... > >>> > >>>SOMEONE PLEASE HELP!!! > >>> > >>>Any help is appreciated as always... > >>> > >>>Thanks, > >>>Ash. > >>> > >>> > >>>------------------------------------------------------------------------ > >>> > >>>_______________________________________________ > >>>mythtv-users mailing list > >>>mythtv-users@mythtv.org > >>>http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users > >>> > >>> > >>> > >>> > >>What nvidia chipset does you setup use? If it's geforce 4 or greater, > >>use the overscan option in the xorg.conf file. > >>For example: > >> > >>Section "Device" > >> Identifier "Videocard0" > >> Driver "nvidia" > >> VendorName "Chaintech" > >> BoardName "nVidia GeForce 4 MX 440" > >> Option "RenderAccel" "1" > >> # TV Out Setup > >> Option "TVStandard" "NTSC-M" > >> Option "TVOutFormat" "SVIDEO" > >> Option "TVOverScan" "0.5" > >> EndSection > >> > >>Increase the value by .05 until the lines disappears. > >> > >>Calvin... > >> > >> > >> > > > > > > > 5.5 is not a valid value, 0.55 is. Perhaps that's what you mean? If it > didn't work try .85 and see if there is any change. Valid values are > between 0.0-1.0 >
_______________________________________________ mythtv-users mailing list mythtv-users@mythtv.org http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users