On 09/11/05, Ben Edwards <[EMAIL PROTECTED]> wrote:
> I have managed to get a good picture in mplayer so I guess my dvb card is
> set up.
>
> When I go to scan shannels it just sits there for about a minute with 'no
> lock' and eventualy gives up and comes up with 'Error tuning to transport';(
What parameters are you entering for the channel scan? I forget how
it's done (advanced something perhaps) but before you do a scan you
have to enter a bunch of parameters related to the dvb transmission
from your local transmitter.
These are what I used for Crystal Palace.
freq 505833330
B/W 8MHz
Inversion Auto
Constellation QAM 16
LP Coderate 3/4
HP Coderate 3/4
Trans Mode 2K
Guard Interval 1/32
Hierarchy None
I worked these out by following this document
Is this defenatly nessesery? I thought leaving things as auto was OK now. I was previously using knopixmyth and it just worked.
http://www.ethics-gradient.net/myth/mythdvb.html
Will have a look at this.
which showed me how to use scan and tzap, from the dvb-utils package.
BTW I'm using 18.1. I believe there have been lots of dvb related
changes in the SVN version, so things may be different now.
I just did emerge mythtv and I think it gave me 18.1, does this make sence.
Regards,
Ben
_______________________________________________
mythtv-users mailing list
mythtv-users@mythtv.org
http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
--
Ben Edwards - Bristol, UK, England
WARNING:This email contained partisan views - dont ever accuse me of using the veneer of objectivity
If you have a problem emailing me use
http://www.gurtlush.org.uk/profiles.php?uid=4
(email address this email is sent from may be defunct)
_______________________________________________ mythtv-users mailing list mythtv-users@mythtv.org http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users